GE Washer Not Draining: Seven of Sixteen Were the Drain Pump

A GE washer that will not drain finishes washing and then just sits there with water in the tub, or stops partway and will not go on to spin. Two of the owners on these jobs saw F18 on the display while it happened. The rest just had a machine that quit with water in it. Either way the washer could not get the water out, and it was not going to finish the cycle until it could.

The usual internet answer is to check the filter. On a GE that is worth doing, but it was the answer once in sixteen. Here is what these actually turned out to be on my last sixteen in Stark County.

What it really was, sixteen times

Put another way: six of the sixteen — the three obstructions, the dime, the frozen hose and the reset — were fixed without a part going into the washer. Seven were a pump. The last three were the expensive end: a board, a transmission, and a set of bearings that ended with the owner buying a new machine.

What you can safely check first

Unplug the washer before you touch anything. If water is going to come out anywhere, have towels and a shallow pan down first.

Add those up and the honest odds are four in sixteen that something you can do at home with the power off clears it. That is worth twenty minutes. But the single most likely answer is still the pump, and the sock and the rock were in the pump intake and the pump itself — getting to those means taking the machine apart, which is where I would stop and call.

The one thing that separates a cheap fix from an expensive one

Plug it back in, start a drain and spin, and listen low on the machine. As a general rule, what you hear, or do not hear, points down very different roads.

F18: two jobs, two different answers

Both F18 machines came in with the same complaint and the same code. One needed a drain pump, and I installed control updates while I was there. The other got a main control board, and I verified it drained before I left. Same code, two different parts. That is why I do not treat a code as a parts order. It tells me where to start looking, and testing the machine tells me where to stop.

Still under warranty? Start with GE

Louisville Appliance Repair is factory-authorized for GE Appliances warranty service, along with Bosch, Thermador and Speed Queen. If your washer is still under the manufacturer’s warranty, start the claim with GE; GE sends warranty calls in this area to its authorized servicers, and that includes us. Not sure whether you are still covered? Check your paperwork, or text me the model and serial number and I will tell you.

What it costs

The service call is $167 for a top-loader and $187 for a front-loader, a little more outside the regular route, and it comes off the repair when you go ahead. You get a flat-rate quote before any work starts, and labor is covered for six months. I have been fixing washers around Stark County since 2018, and I would rather tell you it was a sock than sell you a pump you did not need.

Checked the easy things and the GE is still sitting full of water? Schedule online any time, or call or text (330) 693-9163.