A homeowner in Magnolia, OH called with a Kenmore dryer that wouldn’t start when they pushed the button. The door light came on when opened, but the switch felt loose. We found the door switch had broken and replaced it to restore normal operation. The Problem The customer had just bought the house and wasn’t … Read more
A customer in North Canton called about their Kenmore dryer making noise when running and getting very hot to touch in the upper back. They suspected it might be a belt issue, but after our assessment, they decided to replace the unit instead of proceeding with repairs. The Problem The customer reported that their dryer … Read more
We serviced a Kenmore dryer in Canton, OH that was operating but producing no heat. After testing the heating circuit, we found both the heating element and thermal fuse had failed and needed replacement. The Problem The customer reported their dryer operates but no heat. The unit would run through its cycles normally, but clothes … Read more
A Kenmore dryer at a home on Woodrow Street Northwest in North Canton, OH was running but producing no heat. Our diagnosis revealed a bad thermal fuse that had cut power to the heating element. The Problem The customer reported that their dryer runs but there is no heat. The drum would tumble normally and … Read more
A Kenmore dryer in Hartville wouldn’t start — just hummed when the customer pressed the button. We found the blower was jammed, preventing the motor from turning over properly. The Problem The customer reported their dryer motor won’t start, just hums. This is a classic symptom of mechanical resistance somewhere in the drive system that’s … Read more
A Kenmore 80 Series dryer in Beloit, OH wasn’t heating properly. The homeowner noticed intermittent heating that made clothes take much longer to dry. Our diagnosis revealed failed coil packs on the valve that were causing the inconsistent heating performance. The Problem The customer reported their Kenmore dryer was not heating properly. The unit would … Read more
We returned to a Canton home where we had recently replaced a panel board on a Kenmore dryer. The customer called because the dryer works but it’s not drying clothes properly — they never get completely dry. What we found was a simple but critical oversight from the initial installation. The Problem The customer reported … Read more
A Kenmore dryer on Naomi Street in Akron wasn’t producing any heat despite running normally. Our diagnosis revealed overheated wires caused by loose connections and shorting, requiring a complete terminal block and cord replacement. The Problem The customer reported their dryer runs not getting hot. The unit would complete cycles but clothes remained damp and … Read more
A Kenmore dryer in Malvern, OH wasn’t responding when the customer pushed the start button. The unit appeared completely dead with no response to any controls. After inspection, we found the door switch had failed, preventing the dryer from receiving the signal that the door was properly closed. The Problem The customer reported that their … Read more
A Kenmore dryer in Alliance, OH was showing lights but wouldn’t stay running — it would try to start then shut off immediately. Our diagnosis revealed the issue wasn’t with the dryer itself, but with the electrical supply feeding it. The Problem The customer reported their dryer won’t start, lights are on, and it tries … Read more