Samuel made a service call on West Main Street in Alliance, OH to look at a Whirlpool commercial dryer (model CGM2751KQ3) with a coin box that was jammed and had no key. The diagnostic visit resulted in a parts order to restore access and full operation. The Problem Coin box jammed. No key for it. … Read more
On a service call to Alliance, OH, Samuel found a Maytag top-load washer that kept cutting its cycles short, appearing to drain and then jumping straight to done. The root cause turned out to be a plumbing issue at the standpipe rather than a fault inside the machine itself, and the washer left operating correctly … Read more
A GE top-load washer on Turnbury Street in Alliance, OH was throwing loads off balance, refusing to spin out, and failing to fill to the selected Deep Fill level. Samuel Willhite traced the root cause to a drain hose seated too deep in the standpipe, confirmed the siphoning fault through active diagnostic codes, and resolved … Read more
On a service call to Saint Elmo NE in Canton, OH, Samuel Willhite found a Crosley refrigerator that had been leaking water into both compartments, with a frozen drain tube at the root of the problem. After clearing the blockage and verifying all related components, the refrigerator was back to normal operation with no parts … Read more
Samuel was on a service call to Englewood Dr NE in Canton, OH for an LG dryer making a loud noise during tumbling. The dryer continued to operate but the noise had been going on for about a week. After diagnosing the unit, Samuel found the source of the problem and completed the repair. The … Read more
On a service call to Canton, OH, Samuel Willhite diagnosed a Bosch range that had stopped broiling and was stalling during oven preheat. The broil element tested open, and after replacing it, the unit completed a full preheat cycle from 70°F in 12 minutes and broil operation was confirmed working to spec. The Problem ** … Read more
On a service call to Louisville, OH, Samuel Willhite diagnosed a Whirlpool dryer (model WGD70HEBW1) that would power on but refuse to start. The root cause turned out to be multiple failed mechanical components, including a broken idler pulley, a seized blower wheel stripped on the motor shaft, and a broken motor pulley. After replacing … Read more
Samuel was called out to Kings Court in Leetonia, OH on a Maytag front-load washer that had stopped draining reliably, throwing error codes and requiring the customer to unplug and replug the machine repeatedly after washing a rug. A blocked coin trap and a partially detached door boot were behind the trouble, and the unit … Read more
On a service call to Malvern, OH, Samuel Willhite diagnosed a KitchenAid under-counter ice machine that was cooling normally but producing no ice. The recirculation pump impeller had stripped, leaving water sitting in the reservoir instead of circulating over the evaporator plate. Replacing the pump restored normal operation. The Problem Under-counter ice maker not making … Read more
On a service call to East Canton, OH, Samuel Willhite diagnosed a Hotpoint washer that kept stopping mid-cycle with an off-balance error and filling with only a fraction of the water needed. The root cause turned out to be a simple obstruction in the cold water supply, and once cleared, the machine passed all diagnostics … Read more