Samuel was on a service call on Overridge Ave SE in North Canton, OH, where a Whirlpool top-load washer (model WTW7040DW0) had been throwing an F8E1 long fill error and eventually stopped filling altogether. The water valve was replaced and the washer was back in service. The Problem I got a long fill error a … Read more
On a service call to Canton, OH, Samuel diagnosed a Whirlpool top-load washer that had stopped agitating and was producing a clicking sound during the cycle. The shift actuator had failed, and replacing it brought the machine back to full operation, confirmed by a passed auto diagnostic test and calibration. The Problem Washer is a … Read more
Samuel made a service call to a home on Oakfield Street in East Canton, OH to look at a Whirlpool washer that had stalled on the sensing cycle and would not move forward. No parts were needed. After running the auto diagnostic cycle, the unit was washing normally before Samuel left, and a follow-up call … Read more
Samuel answered a service call in Massillon, OH for a GE washer that was showing a door locked error code and would not start. A previous technician had already visited without resolving the issue, and the customer had replaced the door lock themselves with no improvement. Samuel replaced the main board and the door lock … Read more
A Speed Queen washer on West Maple St in Hartville, OH was leaving laundry stuck inside, with the door refusing to lock. Samuel found a broken door strike lodged in the lid lock assembly and had the unit back in service the same visit. The Problem Problem: Washer door is not locking The Repair ? … Read more
Samuel made a service call to a home on Hoover Ave NW in Uniontown, OH to diagnose a GE front load washer that was filling and draining but leaving every load soaking wet. The inspection turned up foreign objects in the drain pump trap and a failing drum support with bearings that are no longer … Read more
On a service call to Louisville, OH, Samuel Willhite diagnosed a Whirlpool washer that wouldn’t shut off after completing a cycle and had stopped finishing full wash cycles. The culprit was an F3E2 error code pointing to the main control board, which was replaced to restore normal operation. The Problem Whirlpool Washer Pump won’t shut … Read more
A GE top-load washer on McDowell St NE in Canton, OH had completely stopped responding, no power, no display, nothing. Samuel traced the issue to a failed lid lock, out-of-balance faults logged in the machine’s history, and firmware that needed updating. After the firmware update, lid lock replacement, and belt replacement, the washer completed a … Read more
On a service call in Akron, OH, Samuel worked on a Speed Queen washer that was randomly jumping into soak mode on its own, dragging out wash cycles. Replacing the front end, drive board, and touchpads resolved the issue and the machine was running correctly before the call wrapped up. The Problem Automatically goes to … Read more
On a service call to North Canton, OH, Samuel Willhite inspected a Maytag top-load washer (model MVWC565FW1) that had stopped spinning water out of clothes. After examining the machine, Samuel found the damage was too extensive to make repair a practical option. The Problem Not spinning water out The Repair Spin basket hub is stripped … Read more