On a service call to Waynesburg, OH, Samuel found a Whirlpool top-load washer throwing an LF fault and failing to fill properly. The root cause was a failed cold water inlet valve, with a missing or damaged inlet screen allowing rust and sediment into the valve. After replacing the valve and screen and flushing the … Read more
On a service call to East Reno Drive in Louisville, OH, Samuel found a GE front-load washer leaving standing water after every cycle. The customer had already cleaned the filter with no blockage found. After diagnosing a failed load-side command output on the main control board, Samuel replaced the board and confirmed full drain function … Read more
Samuel was on a service call to Alliance, OH for a Whirlpool washer that had stopped mid-cycle with a lid error code, leaving water sitting in the tub and producing a grinding noise. After draining the unit and testing, the diagnosis pointed to worn bearings, and the customer decided to replace the machine rather than … Read more
Samuel was on a service call on Overridge Ave SE in North Canton, OH, where a Whirlpool top-load washer (model WTW7040DW0) had been throwing an F8E1 long fill error and eventually stopped filling altogether. The water valve was replaced and the washer was back in service. The Problem I got a long fill error a … Read more
On a service call to Canton, OH, Samuel diagnosed a Whirlpool top-load washer that had stopped agitating and was producing a clicking sound during the cycle. The shift actuator had failed, and replacing it brought the machine back to full operation, confirmed by a passed auto diagnostic test and calibration. The Problem Washer is a … Read more
Samuel made a service call to a home on Oakfield Street in East Canton, OH to look at a Whirlpool washer that had stalled on the sensing cycle and would not move forward. No parts were needed. After running the auto diagnostic cycle, the unit was washing normally before Samuel left, and a follow-up call … Read more
Samuel answered a service call in Massillon, OH for a GE washer that was showing a door locked error code and would not start. A previous technician had already visited without resolving the issue, and the customer had replaced the door lock themselves with no improvement. Samuel replaced the main board and the door lock … Read more
A Speed Queen washer on West Maple St in Hartville, OH was leaving laundry stuck inside, with the door refusing to lock. Samuel found a broken door strike lodged in the lid lock assembly and had the unit back in service the same visit. The Problem Problem: Washer door is not locking The Repair ? … Read more
Samuel made a service call to a home on Hoover Ave NW in Uniontown, OH to diagnose a GE front load washer that was filling and draining but leaving every load soaking wet. The inspection turned up foreign objects in the drain pump trap and a failing drum support with bearings that are no longer … Read more
On a service call to Louisville, OH, Samuel Willhite diagnosed a Whirlpool washer that wouldn’t shut off after completing a cycle and had stopped finishing full wash cycles. The culprit was an F3E2 error code pointing to the main control board, which was replaced to restore normal operation. The Problem Whirlpool Washer Pump won’t shut … Read more