On a service call to Alliance, OH, Samuel visited a home on Harrisburg Westville Rd where a Kenmore dryer was taking much longer than normal to dry clothes. Testing confirmed a heavily restricted vent as the cause, and no parts were needed to identify the problem. The Problem Extended time. The Repair Performed: Exhaust airflow … Read more
Samuel handled a refrigerator repair on Monter Ave in Louisville, OH where a Kenmore side-by-side was running but not cooling and the freezer had completely stopped freezing. The compressor had failed and was not pumping at all. Samuel replaced the compressor, leak checked the system, pulled it down to vacuum, and recharged it with refrigerant … Read more
On a service call to Canton, OH, Samuel diagnosed a repeat high-limit failure on a Kenmore dryer that had already had the thermal cutoff kit replaced twice. The root cause turned out to be a restricted exhaust vent, not a defective component. Replacing the flexible slinky duct with smooth rigid and semi-rigid duct resolved the … Read more
A Kenmore dryer on 32nd St NW in Canton, OH was brought back to working order after a no-heat complaint that had already gone unresolved. Samuel found a tripped high limit, a blower cover installed backward, and a leaking lint screen duct connection. After correcting all three issues, the dryer was heating properly and ready … Read more
On a service call to Canton, OH, Samuel found a Kenmore dryer that ran through its cycle without producing any heat. The high limit thermal fuse had tripped, and replacing it along with the cycling thermostat brought the dryer back to full operation. The Problem Dryer runs but produces no heat — suspected heating element; … Read more
Samuel was on a service call in North Canton, OH for a Kenmore dryer with worn drum rollers. The right rear roller had failed completely, and with the full repair kit on hand, he had the dryer back up and running the same visit. The Problem Drum roller repair needed; customer has done this repair … Read more
On a service call to North Canton, OH, Samuel Willhite found a Kenmore range that wouldn’t light after a grease spill. The bake igniter was drawing only 2.6 amps, well below the 3.2–3.6 amps needed to open the gas valve. A replacement igniter got the oven lighting reliably again. The Problem Cannot light burner(s) due … Read more
Samuel was on a service call on Shelley Street Northeast in Canton, OH to look at a Kenmore gas dryer that had stopped producing heat. After diagnosing the unit, he found faulty gas valve coil packs and a dry-rotted belt, replaced the worn components, and had the dryer running again before leaving the job. The … Read more
On a service call in Homeworth, OH, Samuel found a Kenmore dryer that was running but producing no heat. A partially obstructed vent and failing gas valve coil packs were the culprits. After cleaning the vent, replacing the coil packs, and clearing out some coins from the drum baffles, the dryer was back in working … Read more
A Kenmore gas range in Canton, OH stopped heating, and the cause came down to a weak oven igniter that wasn’t drawing enough current to open the gas valve. Samuel replaced the igniter on this service call, and the oven was lighting properly before he left. The Problem ** WEBSITE LEAD **Requested: 2026-06-16Notes: Timing details: … Read more