A Canton homeowner called when they noticed dirt and small pebbles on their sheets after a wash cycle. When we opened up this GE washer, we found the spin basket bottom was disintegrated — explaining how debris was getting into the wash water. The Problem When the load of laundry was done, the customer noticed … Read more
A GE washer in Canton, OH was washing fine but erroring out on rinse and leaving water in the tub. Our diagnosis revealed the drain pump running rough, which we resolved with a replacement part. The Problem The customer reported their 7-year-old GE washer washes fine but errors out on rinse and leaves water in … Read more
A GE washer in Canton, Ohio wouldn’t spin consistently for the homeowner. The machine would sometimes complete the spin cycle and sometimes stop mid-cycle, leaving clothes soaking wet. Our diagnosis revealed a worn drive belt that had stretched beyond its ability to maintain proper tension. The Problem The customer reported that their washer won’t spin … Read more
A homeowner in Massillon called about their GE washer being full of water and refusing to run any cycles. When we arrived at the Sweetbriar Circle address, we found the washing machine completely locked up — it wouldn’t even attempt a rinse/drain cycle. The Problem The customer reported their washing machine was full of water … Read more
We recently serviced a GE washer in Akron that still worked but made clicking sounds when turning the drum by hand and banging noises during operation. The unit spun clothes out fine, but the noise indicated a serious mechanical issue that needed immediate attention. The Problem The customer reported their washer still works, but makes … Read more
A GE washer in North Canton was making a very loud noise when agitating. Our diagnosis revealed the pulley was rubbing on the floor of the machine, creating the excessive noise during wash cycles. The Problem The customer reported a very loud noise when agitating. This noise was disrupting the normal wash cycle and indicated … Read more
A GE washer in Minerva, OH stopped spinning and left white plastic shavings in the clothes. The customer had saved some of those shavings to show our technician. Unfortunately, we found that a previous transmission replacement repair had failed completely. The Problem The customer reported their GE washer stopped spinning. They also discovered white plastic … Read more
We responded to a service call in Canton, OH for a GE washer that was filling up, washing, and had water pouring out of the bottom. When we arrived and began testing the unit, the washer started working normally, suggesting an intermittent issue with either the timer or motor control. The Problem The customer reported … Read more
A customer in Minerva, OH called because their GE washer wouldn’t spin the clothes out. When we arrived at the home on U.S. Route 30, we ran the machine through a complete cycle and could not replicate the problem. The Problem The customer reported that their washer won’t spin the clothes out. This left clothes … Read more
A GE washer in Louisville wasn’t getting cold water during fill cycles. The homeowner had already checked their water supply, so we knew the issue was likely inside the machine itself. The Problem Cold water is not filling machine. Water supply checked. Diagnosis We found the water inlet filters were clogged, preventing proper cold water … Read more