A Canton homeowner called when their Maytag washer was not operating correctly. Our diagnosis revealed multiple drive system failures that required transmission replacement along with supporting components. The Problem The customer reported their washer was not operating correctly. The machine wasn’t completing its wash cycles properly, indicating internal mechanical issues. Diagnosis Testing revealed transmission failure … Read more
A Maytag dryer at a home on Noble Street in Alliance wouldn’t start when the customer tried to use it. Our inspection revealed the lint filter was broken and had sucked up a sock, jamming the blower completely. The Problem The customer reported their Maytag dryer won’t start. The unit showed no response when they … Read more
A Maytag refrigerator at a home in Minerva wasn’t working properly, and the customer had multiple appliances needing repair. Our diagnostic revealed a failed main control board and a clogged defrost drain system affecting the unit’s performance. The Problem The customer contacted us about multiple appliances to repair at their Union Avenue location. The Maytag … Read more
A Louisville homeowner called with multiple appliance issues — their Maytag dryer had stopped heating but was still tumbling, their washer was leaking significantly out of the bottom, and their Caloric wall oven wasn’t heating. We found three different problems requiring different approaches to get everything working again. The Problem The customer reported that their … Read more
A Maytag washer in Massillon started smoking during the final spin cycle and stopped working entirely. During the last wash, everything worked fine until the final spin — then there was noise, a cloud of smoke and no spinning. Our diagnosis revealed the issue required immediate attention to prevent further damage. The Problem The customer … Read more
We received a service call for a Maytag dryer in New Philadelphia that would not dry clothes after 1.5 hours. The customer wasn’t sure if it was the timer or heating element causing the problem, but our diagnosis revealed multiple failed components that made replacement the better choice. The Problem The customer reported that their … Read more
A Maytag dryer in Akron wasn’t producing any heat despite the customer’s previous repair attempts. We found the ignitor had power but wasn’t glowing, preventing the gas valve from opening and the burner from lighting. The Problem The customer reported no heat from their Maytag dryer. They had already replaced the thermal fuse and coil … Read more
A Canton homeowner called because their Maytag Centennial washer won’t sense there’s a load and doesn’t do anything. We diagnosed multiple system failures that made replacement the better choice than repair. The Problem The customer reported their washer won’t sense there’s a load and doesn’t do anything when they try to start a cycle. Diagnosis … Read more
A customer in Tallmadge called about their Maytag washer that won’t start. When we arrived at the Beechwood Drive location, we found the issue wasn’t with the washer at all — the GFCI outlet was tripped. The Problem The customer reported their Maytag washer won’t start. Both the washer and dryer were completely unresponsive. Diagnosis … Read more
A commercial laundromat in Canton, OH called with coin-operated equipment troubles. One of the dryers would run without putting money in it and the washer wouldn’t take money. We found failed coin mechanisms on both units that needed immediate attention. The Problem The customer reported that one of the dryers will run without putting money … Read more