A customer in Massillon called us about their GE dishwasher that wasn’t draining. When we arrived at the home on Stahl Avenue Northwest, we found the issue was simpler than expected — a screw had fallen into the pump assembly. The Problem The dishwasher wasn’t draining properly after wash cycles. Water was remaining in the … Read more
A Maytag dishwasher in North Canton wasn’t spraying water or operating properly through the different cycles. Our diagnosis revealed the wash pump had failed, which prevented the unit from circulating water during wash cycles. The Problem The customer reported their dishwasher was not spraying water or operating properly through the different cycles. This meant dishes … Read more
We recently completed a dishwasher repair on East State Street in Salem, OH. The customer reported that water won’t drain out of the bottom. Our diagnosis revealed the dishwasher drain was obstructed. The Problem The customer contacted us because water won’t drain out of the bottom of their GE dishwasher. This is a common issue … Read more
A GE dishwasher in Canton was stuck with an orange light that just kept blinking. The customer had reset it and it ran once, but then the blinking started again. Our diagnosis revealed failed control boards that needed replacement. The Problem The orange light just keeps blinking, we reset it and it ran once now … Read more
A Whirlpool dishwasher on Coty Drive in Canton, OH wasn’t washing dishes properly. When we arrived, we found the circulation pump had failed completely. We replaced the entire sump assembly to restore normal operation. The Problem The customer reported their dishwasher was not washing dishes properly. This is a clear sign that water circulation inside … Read more
A Maytag dishwasher in Sebring wasn’t starting, with four lights staying on the control panel. We diagnosed a failed main control board and replaced it with the correct part. The Problem The customer reported their dishwasher won’t start. They had four lights that stay on the control panel, indicating a control system malfunction. Diagnosis The … Read more
A Kenmore dishwasher in Canton was leaking, and the customer had been told by another company that parts were unavailable. After two service visits, we located the source and replaced the failed lower spray arm, restoring proper operation. The Problem The customer reported their dishwasher was leaking. Mr Appliance had previously told them that replacement … Read more
We completed a dishwasher installation in Canton, OH this week. The customer reported their dishwasher don’t work. Upon arrival, we found the unit needed complete replacement rather than repair. The Problem The customer contacted us because their dishwasher don’t work. The existing unit had reached the end of its service life and required replacement. Diagnosis … Read more
A Whirlpool dishwasher in New Philadelphia wouldn’t wash, leaving the homeowner with dirty dishes piling up. During our service call, we discovered the door latch had failed, preventing the wash cycle from starting properly. The Problem The customer reported their dishwasher won’t wash. When we arrived, the unit appeared to receive power but wouldn’t begin … Read more
An Admiral dishwasher on Harding Ave NW in Massillon had a completely dead control panel with no lights working at all. The customer mentioned it had frozen before with some lights still on, but now nothing responded. We found the door latch had failed, preventing the control panel from activating. The Problem The control panel … Read more