Samuel was on a service call in Uniontown, OH when a Speed Queen dryer came in with a no-heat complaint. After confirming voltage at the terminal block and tracing the fault to an open heater element, Samuel installed a replacement heater kit and had the dryer heating and cycling normally before leaving the home. The … Read more
On a return service call to Corrine Dr NW in Canton, OH, Samuel diagnosed a Speed Queen washer that kept stopping mid-cycle with status lights flashing and water left in the tub. After identifying two distinct error paths from customer-provided videos, he replaced all components involved and confirmed the machine ran through a full cycle … Read more
On a service call to Waynesburg, OH, Samuel found a Speed Queen washer that had stopped advancing past the fill cycle. A loose pressure sensor hose was keeping the machine from sensing the water level, and once the hose was reseated, the washer returned to normal operation. The Problem The water was only trickling into … Read more
Samuel was on a service call in Alliance, OH for a Speed Queen top-load washer that shook badly during spin. He found broken bolts through the basket into the hub and rust on the outer tub. The repair required ordering and replacing the outer tub, gear case, hub, and seal kit. The Problem Top-load washer … Read more
A Speed Queen dryer on Penhurst Cir NE in North Canton was squealing loudly during operation. Samuel found worn support rollers at the root of the noise and completed the repair using Speed Queen’s dedicated maintenance kit, getting the dryer running quietly again. The Problem It’s squealing loudly The Repair Support rollers going bad. Used … Read more
Samuel was on a service call on Reeder Ave NE in Alliance, OH for a Speed Queen dryer that had stopped producing heat. Testing revealed a blown thermal fuse rather than a failed heating element, and after replacing the fuse and cycling thermostat the dryer was back up and running with confirmed good airflow. The … Read more
On a service call to Minerva, OH, Samuel Willhite found a Speed Queen washer with failed tub bearings and a rusted outer drum causing a loud howl during spin and an active water leak. The repair required a full drum assembly rebuild, and the machine was back in service the same visit. The Problem Washer … Read more
On a service call to Canton, OH, Samuel found a Speed Queen washer that had been producing a burnt smell and clanking sounds during use. The culprit turned out to be a rusted and corroded outer tub with a leaking seal, along with a worn idler pulley and belt. After sourcing the correct parts, Samuel … Read more
Samuel visited a home on Corrine Dr NW in Canton, OH on a service call for a Speed Queen washer that was cycling through lock and unlock states repeatedly, leaving water in the tub and failing to complete a wash. After checking water supply and the lid lock mechanism, Samuel was unable to reproduce a … Read more
Samuel was on a service call on Newton Falls Road in Ravenna, OH for a Speed Queen dryer that needed cleaning. The cabinet was packed with lint, the vent connection had come loose, and the existing vent setup raised a concern worth passing along to the customer. The Problem Needs cleaned. The Repair Cleaned lint … Read more