Maytag Dryer Repair (Model LDG8414AAE) – Leetonia, OH
The dryer was running but not heating, taking about 90 minutes to dry a medium load. Replacing the igniter and gas valve coil packs restored proper heat.
The dryer was running but not heating, taking about 90 minutes to dry a medium load. Replacing the igniter and gas valve coil packs restored proper heat.
Dryer ran hot on all settings due to a heating element shorted to the frame. Replaced the element to restore proper temperature control.
Dryer would not start. Failed door switch replaced, restoring normal operation.
Dryer wouldn’t start and later struggled with full loads due to a misinstalled idler pulley. We fitted the OEM pulley correctly and restored normal operation.
A Frigidaire Dryer GLEQ2152ES0 in Alliance, OH was shutting down after a few minutes with flashing lights and an ‘Ad’ message. Replacing the heating element assembly, bearing kit, belt, and idler pulley restored normal operation.
This Whirlpool dryer in Alliance wasn’t heating even though it ran. Replacing a blown high-limit fuse, cycling thermostat, and warped heater restored heat.
The dryer had no heat due to a failed heating element. Installing a new element restored proper cycling and heat.
The dryer made loud squeaks and squeals at startup. Worn drum rollers and a rough idler pulley were replaced, eliminating the noise; heater checked OK.
Dryer had no heat. Replaced the heating element assembly (element, thermal fuse, cycling thermostat) and a worn idler pulley to restore proper drying.
This Amana dryer (NGD5100TQ1) had no heat and the timer wouldn’t advance. Replacing a burned thermal fuse restored proper heating and timer operation.