A GE dryer on Blackburn Road Northwest in Canton wasn’t closing properly and running louder than normal. We found a lint trap that was completely plugged and a blower wheel obstructed with debris. The Problem The customer reported that the door doesn’t close well and the dryer is louder than usual. These symptoms often point … Read more
A Frigidaire Dryer GLEQ2152ES0 in Alliance, OH was shutting down after a few minutes with flashing lights and an ‘Ad’ message. Replacing the heating element assembly, bearing kit, belt, and idler pulley restored normal operation.
This Whirlpool dryer in Alliance wasn’t heating even though it ran. Replacing a blown high-limit fuse, cycling thermostat, and warped heater restored heat.
The dryer had no heat due to a failed heating element. Installing a new element restored proper cycling and heat.
We completed a dryer repair on Woodland Avenue Northwest in Canton, OH for a customer who needed to fix vent. Our technician found the vent needed proper installation and completed the work correctly. The Problem The customer contacted us to fix vent on their Midea dryer. The vent system was not functioning as it should. … Read more
A customer on Woodland Avenue Northwest in Canton called us to fix their dryer vent. When we arrived, we found the vent wasn’t installed correctly, which could impact drying performance and safety. The Problem The customer reported they needed to fix vent on their Midea dryer. The existing vent installation was preventing proper airflow. Diagnosis … Read more
The dryer made loud squeaks and squeals at startup. Worn drum rollers and a rough idler pulley were replaced, eliminating the noise; heater checked OK.
Dryer had no heat. Replaced the heating element assembly (element, thermal fuse, cycling thermostat) and a worn idler pulley to restore proper drying.
This Amana dryer (NGD5100TQ1) had no heat and the timer wouldn’t advance. Replacing a burned thermal fuse restored proper heating and timer operation.
A Samsung dryer in North Canton wasn’t heating up, leaving clothes damp after full cycles. Our diagnosis revealed a failed high limit thermostat on the blower housing — a safety component that shuts off heat when temperatures get too high. The Problem The customer reported that their electric dryer was not heating. The drum would … Read more