Whirlpool Washer Repair (Model WFW9151YW00) – Carrollton, OH
Washer door was stuck locked with E2/F3 errors. Repaired broken temperature sensor harness and replaced the drain pump to restore normal operation.
Washer door was stuck locked with E2/F3 errors. Repaired broken temperature sensor harness and replaced the drain pump to restore normal operation.
This Whirlpool washer left loads soaking wet due to a stripped drive hub. We replaced the hub and restored spin; a transmission may be needed if it recurs.
Dryer squeaked and rumbled due to worn support rollers and idler pulley. Installed Whirlpool kit with new rollers, idler, and belt to restore quiet operation.
This Whirlpool dryer was running but not heating due to a failed heating element. Replacing the element restored proper drying.
Whirlpool refrigerator GI6SARXXF06 had a seeping water inlet valve that froze the ice maker fill. Replaced the valve and cleared the line to restore ice.
This Whirlpool dryer wasn’t drying due to a failed timer causing intermittent heat. Replacing the timer restored consistent heat and normal drying.
The ice maker was dripping during fill and freezing into a solid block. Replacing the ice maker assembly restored normal ice production.
The refrigerator stopped making ice due to a non-cycling ice maker. Replacing the ice maker restored normal ice production.
Whirlpool stove had stripped valve stems causing two burners to not shut off reliably. Replaced the front valve manifold (all four valves) to restore control.
The Whirlpool dryer was set up for natural gas while the home uses propane. We installed an LP conversion kit and calibrated burner settings for safe, efficient heat.