A Maytag washer at a residence on Bank Lane Southeast in New Philadelphia was stuck on rinse cycle. Our diagnosis revealed the pulley had come off of the bottom of the transmission, requiring reinstallation with locktite. The Problem The customer reported their Maytag washer was stuck on rinse cycle. The machine would not advance through … Read more
The Maytag washer was not functioning properly, making a humming sound after a brief operation. The issue was resolved by correcting the hose installation.
The Maytag washer was malfunctioning, only spitting out water and then humming. After correcting the hose installation, it now operates properly.
A North Canton homeowner called about their Maytag washer with a drum not spinning to wring clothes. When we opened up the MVWX655DW1, we found the hub under the wash plate was completely stripped out — a common wear point on this model that prevents proper spin cycle operation. The Problem The customer reported their … Read more
A Maytag washer in Massillon wasn’t spinning properly, leaving clothes soaking wet even after extended spin cycles. We diagnosed a failed hub and replaced it with a new W10528947 part. The Problem The machine doesn’t seem to be spinning correctly, the clothes are still soaking wet at the end of the cycle, even with additional … Read more
A Maytag washer in Atwater, OH stopped spinning out clothes properly. The customer reported the hub was stripped and the machine wasn’t spinning out. Our diagnosis revealed a stripped spin hub that would require significant disassembly to access. The Problem The customer called because their Maytag washer hub was stripped and not spinning out. The … Read more
A Canton homeowner contacted us about their Maytag washer making a loud screeching noise when initially filling with water and stopping during the fill cycle. Upon inspection of this MVWX655DW1, we discovered internal damage that made repair uneconomical. The Problem The customer reported a loud screeching noise when initially filling with water. The unit stops … Read more
We diagnosed a Maytag washer in North Canton that wouldn’t continue through wash cycle. After inspecting the unit, we found the motor bearings had failed completely. The Problem The customer reported their washer won’t continue through wash cycle. The machine would start but fail to progress through the complete washing sequence. Diagnosis Our inspection revealed … Read more
A Maytag washer in Massillon wasn’t spinning clothes dry, leaving items very wet after cycle. The customer had already checked to make sure it was level, but the problem persisted. Our diagnosis revealed error codes F0E5 (off balance load detected) and F7E6 (motor fault), pointing to a mechanical failure in the spin system. The Problem … Read more