We received a service call from Canton for an Amana dryer that required two dry cycles to finish loads and was making tumbling sounds during operation. Our diagnosis revealed failed drum support components and a heavily obstructed dryer vent causing the extended drying times. The Problem The customer reported that when drying clothes, they had … Read more
A customer in Akron called about their GE dryer that wasn’t working and only made a humming sound. When we inspected the DWSR463EG7WW, we found the motor was stalled and the control panel was broken beyond repair. The Problem The dryer wasn’t working and only made a humming sound when started. The customer reported no … Read more
The dryer was not turning on, but after repairing a cracked solder joint on the control board, it now functions properly.
The dryer was not producing heat, causing laundry to remain damp. The heating element was replaced to restore functionality.
The gas dryer was running but not producing heat. Replacing the heating element and door switch resolved the issue.
The homeowner reported that both the washer and dryer were not functioning. The issue was resolved by clearing a sock from the washer’s drain pump.
The dryer was not heating due to a faulty flame sensor, which was replaced to restore functionality.
The dryer was not drying clothes effectively, likely due to a power issue. An electrician was recommended to check the breaker panel.
The dryer wasn’t heating and wouldn’t stop when the door was opened. A damaged wiring harness was the main issue, leading to broken wires.
The dryer wouldn’t turn on after being overloaded with wet clothes. A thorough inspection revealed the issue was due to the excess weight.