A GE dishwasher in Alliance was getting H2O error code, then after the customer replaced the water inlet valve, it just wouldn’t start cycle at all. We found the main control board had failed and needed replacement. The Problem The customer reported their dishwasher was getting H2O error code about a week ago. They replaced … Read more
A Canton homeowner called about their GE over-range microwave’s underside light that stopped working completely. The light is programmable to come on at night as a night light and turn off in the morning, but reprogramming wasn’t solving the problem of the light not coming on at all when the front panel button was pushed. … Read more
A homeowner in Massillon called us about their GE dryer that was squeaking pretty badly, with the friction point appearing to be where the drum contacted the front left corner. They had temporarily stopped the noise with WD40, but it returned after 3-4 cycles, and they could see the felt gasket was out of place. … Read more
We completed a gas oven repair in Canton, OH for a customer whose GE oven would turn on to heat up but wouldn’t reach the set temperature and would begin to lose heat. Our diagnosis revealed the oven bake igniter was out of specs and needed replacement. The Problem The customer reported their gas oven … Read more
A customer in Canton, OH called about their GE Profile refrigerator that won’t freeze or keep food cool. Our diagnosis revealed a failed inverter board on the compressor, which we replaced to restore proper cooling operation. The Problem The customer reported their refrigerator won’t freeze or keep food cool. This meant no cooling in either … Read more
A GE refrigerator in Malvern, OH wasn’t cooling well, leaving the homeowner with warming food and concerns about spoilage. Our diagnosis revealed a failed start relay overload device and a broken mullion between the refrigerator doors. The Problem The customer reported their GE refrigerator was not cooling well. This type of cooling issue can stem … Read more
We returned to a GE washer on Auburn Avenue Southeast in Canton, OH that we’d repaired a couple months earlier. The customer reported it was fine and quiet until yesterday, then became very very loud and doesn’t sound right when spinning. Our diagnosis revealed a more serious underlying issue than the original repair could address. … Read more
A GE refrigerator in Akron wasn’t maintaining proper temperature despite being set correctly. The refrigerator temperature was at 50 degrees even though it was set at 35 degrees. Our diagnosis revealed a failed evaporator fan preventing proper air circulation in the fresh food compartment. The Problem The customer reported that the refrigerator temperature is at … Read more
A GE Cafe refrigerator in Massillon was having water dispenser issues. Our water filter does not have pressure to push the water out, and it makes a weird noise sometimes when trying to get the water out. The hot water won’t work at all, though the ice still does. We found the water supply valve … Read more
A GE refrigerator in Canton started making a humming sound that would stop when turned off and back on. The 7-year-old unit was still cooling properly, but the customer was concerned about potential failure. We found the evaporator fan motor had developed the noise and replaced it to restore quiet operation. The Problem The customer … Read more