A Frigidaire dryer on Johnson Ave in Louisville was making noise during operation. Our diagnosis revealed motor bearings going out, requiring a complete motor replacement to restore quiet operation. The Problem The customer reported their Frigidaire dryer was making noise during cycles. This type of noise complaint often points to worn internal components that need … Read more
A Kenmore dryer on Deacon Avenue Northwest in North Canton wasn’t advancing through its timer cycles properly. The customer reported the timer is not advancing, but our diagnosis revealed the real culprit was severely restricted airflow causing the unit to stop prematurely in auto cycles. The Problem The customer reported that the timer is not … Read more
Dryer stopped spinning after earlier work on the heater. A seized idler pulley was replaced, restoring drum rotation and normal operation.
The dryer stopped spinning due to a split drum that locked up. We installed an LG warranty replacement drum, restoring normal operation.
Dryer would only run when the dial was held and shut off at random. Replacing a failed timer restored consistent, hands-free operation.
Dryer squeaked and underheated due to an open heating element and worn drum bearing. Replaced element and bearing kit to restore heat and quiet operation.
A dryer repair call in Canton brought us to a home where an Admiral dryer was spinning but not receiving hot air. We found two of the three element wires burnt out, along with severely plugged ductwork that was restricting airflow. The Problem The customer reported their dryer spins but not receiving hot air. The … Read more
We serviced an Amana dryer in Salem, OH that had no heat to dry and a timer that doesn’t work. Our diagnosis revealed the dryer needed a new timer, though the customer indicated they would likely replace the unit instead. The Problem The customer reported no heat to dry and timer doesn’t work on their … Read more
We received a call from a tenant on Roseland Road in Alliance, OH reporting their Frigidaire dryer was making a loud noise. When we arrived, we found the belt had broken and the pulley was rubbing on the shaft of the motor causing considerable noise. The Problem The dryer was making a loud noise during … Read more
A Whirlpool dryer in Louisville wasn’t shutting off and had no heat, leaving clothes damp after hours of running. The customer also reported the door handle had broken off completely. Our diagnosis revealed the real culprit was simpler than expected. The Problem The customer called because their dryer runs but timer doesn’t work dryer doesn’t … Read more