A Maytag washer on Denver Drive in Youngstown stopped mid-cycle and wouldn’t drain, with a hot plastic smell developing. Our diagnosis revealed a motor overheating issue on this LAT9616AAE model, but unfortunately the motor is no longer available for replacement. The Problem The washer will start a load and half-way into the cycle it stops … Read more
A customer on West South Range Road in Alliance, OH called us about their Maytag washer not draining fully and clothes coming out soaking wet. After moving the unit upstairs, multiple fault codes had stored in the control system, pointing to various sensing errors. The Problem The customer reported their washer was not draining fully, … Read more
The Maytag dryer wasn’t blowing air due to a cracked blower wheel. After replacing it, the dryer is now operating properly.
The washer was slow to drain and hesitant to cycle, leading to a clogged pump issue. The repair involved replacing the shift actuator and cleaning inlet screens.
The dryer was screeching and noisy, requiring a new rear support roller to restore quiet operation.
The washer wouldn’t spin and displayed a ‘sensing load’ error. After replacing the actuator and cleaning the inlet filter, it now runs smoothly.
The dryer wouldn’t start due to a failed door switch. Replacing it restored functionality.
A Canton homeowner called after accidentally spilling a cup of coffee on their Maytag stove top. The unit immediately tripped the breaker when plugged in, with sparks and smoke coming from the back knob. We found coffee damage to the ignition switch assembly that required complete replacement. The Problem The customer reported that a cup … Read more
A North Canton homeowner called us about their Maytag oven that wasn’t heating properly. The oven took 30 minutes to reach 350 degrees, then immediately started cooling down while still showing it was at temperature. A failed bake element was causing the temperature control issues. The Problem The oven was not heating properly nor maintaining … Read more
A Maytag refrigerator in Alliance developed concerning symptoms — front panel lights blinking on and off slowly with compressor cycling sounds. While the refrigerator stayed cold and internal lights worked, the control board had clearly failed and needed immediate attention. The Problem The customer reported that front panel lights started blinking on and off slowly … Read more