A customer in Minerva called with a GE gas oven that wouldn’t light. The ignitor had failed, leaving the oven unable to start the gas burner cycle. The Problem The customer reported that their oven won’t light. When they tried to use the oven, nothing happened — no ignition, no flame. Diagnosis We found the … Read more
A Maytag washer at 101 Murray Avenue in Minerva, OH was leaking out of the bottom. Our diagnosis revealed a failed transmission assembly — a relatively common issue with these washers where the tub seal fails and water damages the bearings. The Problem The customer reported their Maytag washer was leaking out of the bottom. … Read more
We received a call from a customer in Minerva, OH about their Admiral washer that runs sporadically. After diagnosis, we found the transmission had failed and the power cord was faulty — two critical components that explain the intermittent operation. The Problem The customer reported their washer runs sporadically. The unit was approximately 3 years … Read more
A Whirlpool washer in Minerva, OH was not draining properly and giving error messages F21 and SUD. Our technician found a sock stuck and obstructing the line before the drain pump, which was preventing proper drainage and causing the error codes. The Problem The customer reported that their Whirlpool washer was not draining properly and … Read more
A Frigidaire gas oven at a Minerva home wouldn’t preheat, leaving the homeowner unable to bake or roast. Our diagnosis revealed a failed bake igniter — the most common issue with Frigidaire and Electrolux gas ovens. The Problem The customer reported that their Frigidaire oven won’t preheat. The unit would not reach cooking temperature, making … Read more
A Frigidaire all-refrigerator in Minerva, OH wasn’t cooling despite the customer’s troubleshooting efforts with another repair service. The unit was purchased in 2019, and while the compressor was getting warm and the fan was running, the refrigeration system had failed completely. The Problem Not cooling. Unit is an all-refrigerator purchased in 2019. Called another repair … Read more
A brand new Whirlpool washer failed to cycle after coin insertion. The issue was resolved by resetting the control board and door lock.
The washer was not draining due to a sock stuck in the pump. After removal, it resumed normal operation.
The refrigerator was not cooling while the freezer remained fine. The issue was resolved by defrosting the air intake and cleaning the ice blockage.
The washer was stuck on the spin cycle and displaying a UL code. Replacing the bearing kit and rotor resolved the issue.