A Whirlpool washer on S Main St in Akron was filling up and attempting to click into wash cycle, then draining without washing even though the agitator did move. We found an F9 E1 error code stored in the system but the unit successfully passed auto diagnostic test and calibration with no current faults. The … Read more
A customer in Canton called about their Whirlpool washer leaving clothes still wet after the spin cycle, though some settings were still working. Our diagnosis revealed a plugged cold water screen that was preventing the machine from completing its final rinse cycle. The Problem The customer reported that clothes were still wet after the spin … Read more
A Whirlpool washer repair in Alliance brought us to a commercial property where the RTW4516FW2 would not drain. Our diagnosis revealed failed components in both the water management system and drain pump assembly. The Problem The customer reported that their Whirlpool washer will not drain. This left clothes sitting in standing water at the end … Read more
A Canton homeowner called about their Roper washer that won’t cycle. Our diagnosis revealed multiple failures that made repair uneconomical for this older unit. The Problem The customer reported their washer won’t cycle through its wash programs. Diagnosis Testing revealed an F9E1 error code indicating the cold water valve had failed. Further inspection showed the … Read more
We responded to a service call on Mc Call Road in Garrettsville, OH for a Whirlpool washer with an agitator not working. What appeared to be a mechanical failure turned out to be a water supply issue affecting the entire home’s plumbing system. The Problem The customer reported that the agitator was not working on … Read more
A customer in Alliance, OH called about their Whirlpool washer that wouldn’t complete cycles properly. The washer would wash and drain but then blink on the wash cycle without spinning, forcing the customer to wring out clothes by hand. Our diagnosis revealed a faulty lid lock assembly triggering an F5E1 error code. The Problem The … Read more
A Whirlpool washer in Minerva had an agitator that wouldn’t spin. When we opened it up, we found the agitator was stripped and needed replacement. The Problem The customer reported that the agitator won’t spin. This left clothes poorly cleaned since the agitator provides the washing action that moves water and detergent through the load. … Read more
A Whirlpool washer at 816 Lilly Rd NW in Minerva, OH wasn’t agitating properly. The customer reported the agitator not working. When we arrived, the machine was displaying error code F5E3 – LID UNLOCK FAULT, and we discovered the splutch assembly had broken. The Problem The customer called because their washer’s agitator not working. The … Read more
A North Canton customer called us about their Whirlpool washer that changed a couple of parts on it but it just won’t engage into any cycle and when it did it had a strange noise. Our diagnosis revealed major internal component failures that made repair economically unfeasible. The Problem The customer reported they had changed … Read more