We responded to a service call in Navarre, OH for a Whirlpool dryer displaying error codes. The customer reported their dryer was flashing F6, E3 and wouldn’t operate properly. Our diagnosis revealed a failed control board that needed replacement. The Problem The customer contacted us about their Whirlpool dryer flashing F6, E3 error codes. These … Read more
A Whirlpool washer and dryer set in Minerva wasn’t cooperating with the homeowners. Both doors are not shutting properly, making it impossible to run either appliance. Our diagnosis revealed failed door hardware on both units that needed immediate replacement. The Problem The customer reported that both doors are not shutting properly on their Whirlpool washer … Read more
A Whirlpool refrigerator on Southridge Drive in Salem quit working completely, with the interior light and temperature display numbers flashing continuously. Our diagnosis revealed a failed control board that needed immediate replacement to restore normal operation. The Problem The customer reported that their refrigerator quit working. The light in fridge and numbers for fridge and … Read more
We responded to a service call in Massillon for a Whirlpool dryer that was not heating. The customer had already checked the lint trap and vent, which looked clear, but the dryer still wouldn’t produce any heat. Our diagnosis revealed a bad heat element that needed replacement. The Problem The customer reported that their dryer … Read more
We responded to a service call on Marlboro Avenue Northeast in Louisville, OH for a Whirlpool washer that goes through cycle then goes back to wash and does nothing. The customer reported it was not spinning out. Our diagnosis revealed a plugged cold water screen causing the machine to error out on final rinse. The … Read more
A Whirlpool washer in Akron was leaking from bottom. Our technician found the pump was leaking and replaced it along with the agitator dogs to restore proper operation. The Problem The customer reported their Whirlpool washer was leaking from bottom. Water pooling under the machine is never a good sign and typically indicates a failed … Read more
A Whirlpool dryer in Berlin Center wouldn’t power on despite having electrical power at the outlet. Our diagnosis found the user interface control had failed and needed replacement. The Problem The customer reported their dryer will not power on. They had already checked power to the plug and confirmed electricity was reaching the unit. Diagnosis … Read more
We serviced a Whirlpool washer in East Canton that was tripping the GFCI. The customer couldn’t run a load without the circuit breaker shutting off power to the laundry room. Our diagnosis revealed a faulty lid switch causing an electrical fault. The Problem The customer reported their Whirlpool washer was tripping the GFCI. Every time … Read more
A coin-operated Whirlpool washer in Minerva, OH was freezing up with all lights coming on but no operation. After troubleshooting, we discovered the real culprit wasn’t the washer itself but a plumbing issue affecting its performance. The Problem The customer reported that every time they tried to use the washer it would freeze up and … Read more
A Whirlpool upright freezer in Canton, OH wasn’t cooling properly and had its alarm sounding constantly. The homeowner reported that stuff was kind of frozen, but not as it should be. We found a failed defrost heater causing the cooling issues. The Problem The customer called because their upright freezer was not cooling well and … Read more