A GE oven on Carr Road in Applecreek, OH was showing no power at all. The homeowner couldn’t get any response from the unit when trying to turn it on. Our diagnosis revealed an electrical issue outside the appliance itself. The Problem The customer reported no power to their GE oven. The unit was completely … Read more
A Maytag refrigerator in Lime Springs wasn’t cooling properly, leaving the customer without proper food storage. Our diagnosis revealed a failed control board that needed replacement to restore normal operation. The Problem The customer reported their Maytag refrigerator was not cooling. This left both the fresh food and freezer compartments unable to maintain proper temperatures. … Read more
A Frigidaire refrigerator in North Canton was beeping 5 times repeatedly. We found the door hinge was bent and the door was not engaging the door switch. We straightened the door hinge to resolve the issue. The Problem The customer reported their Frigidaire refrigerator beeps 5 times. This continuous beeping indicated the refrigerator was detecting … Read more
Our team responded to an Akron service call for an LG front-load washer with a bad water leak from the front of the drum area. Upon inspection, we found a dispenser overflow causing the leak and requiring housing and screen replacement. The Problem The customer reported a bad water leak from front of washer drum … Read more
A customer in Minerva called about their LG washer that was making continuous pumping sounds even when turned off. When we arrived at the home on Union Avenue SE, we found the drain pump relay on the control board was stuck in the on position. The Problem The customer reported that when turned off, the … Read more
A Samsung dryer in Akron started making loud squeaking noises while running, then made a loud “clunk” and wouldn’t start operating again. The customer suspected it needed a new belt, but our diagnosis revealed the idler pulley had failed instead. The Problem The dryer started making loud squeaking noises while running. While drying, it made … Read more
A Maytag washer in Northfield, OH was spinning but wouldn’t drain what little water was in the drum and wouldn’t start a wash cycle. Our diagnosis revealed the pressure sensor temperature control combination switch had failed, preventing the machine from adding water to the tub. The Problem The customer reported their Maytag washer would spin … Read more
We received a service call in Cuyahoga Falls for an Admiral oven that wouldn’t turn on. The customer reported that the oven does not come on and the oven light does not come on either. What we discovered was a simple but confusing control setting issue. The Problem The customer called because the oven does … Read more
A Haier refrigerator on Murray Street NW in Canton wasn’t keeping the refrigerator compartment cold enough, though the freezer worked fine. Our diagnosis revealed a failed defrost timer that wasn’t cycling the unit through proper defrost cycles. The Problem The customer reported that the freezer works fine, but the fridge is cool but not cold. … Read more
A customer in Canton, OH called about their LG washer that squeaks in wash cycle. Our diagnosis revealed the wash plate was stripped on the transmission shaft, requiring a pulsator assembly replacement. The Problem The customer reported their LG washer squeaks in wash cycle. This type of noise typically indicates mechanical wear in the agitation … Read more