Kenmore Washer Repair (Model 417.48102700) – Alliance, OH
The washer was beeping continuously and wouldn’t shut off, requiring a breaker reset. A new control board was installed to resolve the issue.
The washer was beeping continuously and wouldn’t shut off, requiring a breaker reset. A new control board was installed to resolve the issue.
The refrigerator was not cooling while the freezer was functioning properly. The temperature control was replaced to resolve the issue.
The washer wouldn’t spin due to a sensor issue, but broken wires on the motor were repaired to restore functionality.
The washer had a filter and pump issue, but after replacing the pump, it was tested and is now functioning properly.
The freezer was not cooling, but after replacing the evaporator fan, it is now functioning properly.
The dishwasher’s sprayers weren’t functioning, but after replacing the plate and support, it is now working fine.
The dryer was running but not heating. After replacing the heater coil valves, idler pulley, and drum support wheel, it started heating properly.
The washer displayed a SUD error during the rinse cycle, preventing it from washing clothes. The issue was likely due to excessive soap usage or failing bearings.
The washer stopped before completing the wash cycle, but after replacing the bearing kit and shaft, it now runs smoothly.
The dishwasher was not getting water and was humming. The pressure switch was installed to resolve the issue.