A Kenmore dryer at a Cuyahoga Falls home was not getting hot. Our diagnosis revealed multiple component failures that were preventing proper heating and operation. The Problem The customer reported that their dryer was not getting hot. The unit would run through cycles but clothes came out damp and cold, indicating a complete loss of … Read more
We responded to a washer repair call in Uhrichsville, OH where the customer reported the lid wasn’t closing all the way, then it just dropped with a snapping sound and everything stopped with the washer full of water. Our diagnosis revealed a failed lid switch that needed immediate replacement. The Problem The lid wasn’t closing … Read more
A Kenmore refrigerator in Canton, OH had an ice maker motor not spinning hard enough to move the ice. Our diagnosis revealed the ice dispenser bin had broken, preventing proper ice dispensing operation. The Problem The customer reported that the ice maker motor was not spinning hard enough to move the ice. This affected the … Read more
A Canton homeowner called about their Kenmore washer with what they suspected were stripped gears. When we arrived at the David Avenue home, we discovered the real issue wasn’t mechanical failure — it was operator overload. The Problem The customer reported that gears may be stripped in their Kenmore washer. They were experiencing operational issues … Read more
A customer in North Canton called about their Kenmore washer tripping the breaker, mostly on spin cycle. When we arrived at the Lorrell Avenue Southwest location, we found the timer was causing the electrical issue and replaced it to restore normal operation. The Problem The washer was tripping the breaker during operation. The problem occurred … Read more
A commercial Kenmore washer repair in Alliance brought us to a busy nail salon where the front-load machine wouldn’t start. The door wouldn’t latch properly, and pressing start only produced humming and buzzing sounds. We found the door lock latch assembly had completely failed. The Problem The customer needed a service call on their front … Read more
A Kenmore oven in North Canton had two problems: the left front burner wasn’t working and the broiler wouldn’t ignite despite the ignitor glowing. We found the issue was in the harness with surface igniter switches, which needed complete replacement. The Problem The customer reported issues with the left front burner, the small burner. The … Read more
The dryer was not turning on, but after repairing a cracked solder joint on the control board, it now functions properly.
The washer wouldn’t agitate or spin properly, likely due to a stripped gear. Replacing the hall sensor resolved the issue.
The homeowner reported that both the washer and dryer were not functioning. The issue was resolved by clearing a sock from the washer’s drain pump.