A Canton homeowner called about their LG oven losing temperature after preheating. After pre-heat temp is reached in the oven, the temp is not maintained and drops off. We found a failed ignitor that couldn’t maintain the gas flame needed to hold steady temperatures. The Problem After pre-heat temp is reached in the oven, the … Read more
A North Canton customer called about water leaking onto the floor from underneath their LG washer. When the filter was removed, more water than normal gushed out, leading to concerns about a possible drain line blockage. We found the hot water valve was seeping and needed replacement. The Problem Water was leaking onto the floor … Read more
A Canton homeowner called about their LG refrigerator with the freezer getting to temp but refrigerator section not cooling. Our diagnosis revealed blocked airflow pathways preventing proper circulation between compartments. The Problem The customer reported their top/bottom freezer refrigerator had a freezer getting to temp but refrigerator section not cooling. This is a classic airflow … Read more
The washer was making a grinding noise during cycles, which was resolved by replacing the bearing housing assembly.
The washer displayed an OE error and failed to drain, preventing it from completing cycles. The water pump was replaced to resolve the issue.
We responded to a service call in Canton, OH for an LG washer that was powering on but the control panel would go blank and power off when choosing a cycle. The customer had already contacted LG support who walked them through a reset, but the washer lost power again mid-cycle with the same repeat … Read more
The LG dryer was not heating despite turning on and spinning. A faulty high limit thermostat was replaced, restoring heat functionality.
The washer was leaking more than usual, and the dryer displayed a d80 error code. We replaced the drain hose and referred the customer for vent cleaning.
A Canton homeowner called about their LG washer displaying an LE error code and refusing to switch out of the wash cycle. When we arrived at the Diamond Street Northeast location, we found a straightforward solution that didn’t require any replacement parts. The Problem The customer reported getting an LE error code repeatedly, and the … Read more
A Canton, OH customer contacted us about their Kenmore front load washer displaying an LE error code. Our diagnosis revealed a failed hall sensor that needed replacement to restore normal operation. The Problem The customer reported that their Kenmore front load washer was showing “LE” on the display. This error code typically indicates a motor-related … Read more