On a service call to Wayne Avenue in Canton, OH, Samuel Willhite checked out a Maytag top-load washer (model MVWB765FW3) that the customer believed had a moisture or filter issue. After running the auto diagnostic cycle, the washer passed with no faults found and no parts needed. The Problem Moisture issue — customer suspects dirty … Read more
Samuel visited a home on Millerton St SE in Canton, OH on a service call for a Maytag top-load washer (model MTW7000EC) that would not lock its lid. Diagnostics traced the problem to a faulty third-party replacement control board and a physically damaged lid lock assembly. Before Louisville Appliance Repair could complete the repair, another … Read more
On a service call to Alliance, OH, Samuel found a Maytag top-load washer that kept cutting its cycles short, appearing to drain and then jumping straight to done. The root cause turned out to be a plumbing issue at the standpipe rather than a fault inside the machine itself, and the washer left operating correctly … Read more
Samuel was called out to Kings Court in Leetonia, OH on a Maytag front-load washer that had stopped draining reliably, throwing error codes and requiring the customer to unplug and replug the machine repeatedly after washing a rug. A blocked coin trap and a partially detached door boot were behind the trouble, and the unit … Read more
On a service call to North Canton, OH, Samuel Willhite inspected a Maytag top-load washer (model MVWC565FW1) that had stopped spinning water out of clothes. After examining the machine, Samuel found the damage was too extensive to make repair a practical option. The Problem Not spinning water out The Repair Spin basket hub is stripped … Read more
A Paris, OH customer called about her Maytag washer starting to make noises and then stopping mid-spin. When we pulled the diagnostic code and traced the issue back to the water inlet, the culprit turned out to have nothing to do with the washer itself — it was a freshly installed water softener hooked up … Read more
A Maytag Bravos XL top load washer on Carroll St in Minerva, OH was giving its owner repeated UL error codes and would not complete a spin cycle, with the tub visibly off-center despite multiple attempts to rebalance the load. Samuel arrived at the home to diagnose the unit and found the repair was not … Read more
Louisville Appliance Repair recently visited a home on Sturbridge Drive in Louisville, OH, to take a look at a Maytag washer, model MVW6230RHW1, that was producing a smoke smell when plugged in. The unit was found to be completely dead, and the diagnosis pointed to a shorted drain pump along with a faulty control board. … Read more
Louisville Appliance Repair recently visited a customer on West 10 St in Salem, OH, to address a Maytag washer that would not start. Samuel found a stored error code pointing to repeated door lock failures, cleared the code, and ran the unit through test mode with all functions performing normally. No parts were needed at … Read more
Louisville Appliance Repair recently completed a service call in Bolivar, OH, for a Maytag washer, model MHW5100DW0, that would power on but not start a cycle. Samuel visited the home on Olde Orchard Drive Northeast and found that the door latch plug was not connected correctly, along with a separate issue involving failing tub bearings. … Read more