A Maytag washer at a home on Bank Lane Southeast Rear in New Philadelphia, OH was reported to be stuck on the rinse cycle. Samuel visited the address to diagnose the issue and found that the pulley had come off the bottom of the transmission, which he reinstalled using Loctite. An actuator was also replaced … Read more
Louisville Appliance Repair recently completed a service call in New Philadelphia, OH, where a Maytag front-load washer, model MAH6700AWW, was leaking water from the left side and going out of balance during the final spin cycle. Samuel visited the home on Coral Key Drive Southeast and replaced the drain line to resolve the issue. The … Read more
Louisville Appliance Repair recently completed a service call on 2nd St NE in Canton, OH, where a Whirlpool washer, model WTW5500XW1, was not spinning properly. Samuel visited the home to assess the issue and determined the machine needed a new motor. The customer decided to purchase a new appliance rather than proceed with the repair. … Read more
Louisville Appliance Repair recently completed a washer repair for a customer on Klines Drive in Girard, OH. The Admiral washer, model GFWR2700HOWW, was leaving water running continuously, though the unit functioned normally when operated manually. Samuel visited the home, found the cold water valve sticking open, and resolved the issue by replacing the water valve … Read more
Samuel recently visited a home on Aetna St in Salem, OH, to take a look at a Crosley washer that had stopped mid-cycle and left the drum full of water. The customer had tried restarting the machine in several modes and even attempted a motor reset, but nothing responded when the knob was pulled. Samuel … Read more
A GE washer at a home on Carriage Lane in Alliance, OH was having trouble starting cycles correctly, jumping to the final rinse instead of beginning normally and failing to spin out. Samuel visited the home to diagnose the issue and found a loose tub nut. Tightening the nut resolved the problem, and the washer … Read more
The coin slot was jammed, preventing proper operation. After clearing the jam, the washer is now functioning correctly.
The washer wouldn’t drain, preventing the rinse and spin cycles from completing. Replacing the lid switch resolved the issue.
The washer wouldn’t agitate or spin properly, likely due to a stripped gear. Replacing the hall sensor resolved the issue.
The washer was reported out of order but is now functioning after a service door lock replacement.