A customer in Alliance called about their LG washer that had the cold hose spraying out the back when trying to connect. When we arrived, we discovered the washer wouldn’t start, which prevented us from seeing where it was leaking. The Problem The customer reported that the cold hose sprays out the back when trying … Read more
A Canton homeowner called when their Maytag washer was not operating correctly. Our diagnosis revealed multiple drive system failures that required transmission replacement along with supporting components. The Problem The customer reported their washer was not operating correctly. The machine wasn’t completing its wash cycles properly, indicating internal mechanical issues. Diagnosis Testing revealed transmission failure … Read more
A customer in Alliance called about their LG washer only delivering hot water instead of cold. What looked like a major repair turned out to be a simple plumbing mix-up that we sorted out in minutes. The Problem The customer reported they weren’t getting cold water to wash with and were only getting hot water … Read more
We responded to a service call on Ethel Street NW in Canton, OH for an Admiral washer that was vibrating a lot and had developed the smell of burnt rubber. The customer suspected a belt or motor issue, but our diagnosis revealed a more serious problem with the machine’s bearing assembly. The Problem The customer … Read more
A Whirlpool washer in North Benton wasn’t starting because the lid wouldn’t lock. When we diagnosed this WTW5600XW0, we discovered multiple major component failures that made repair impractical. The Problem The customer reported that the lid does not lock. The lid needs to lock for the washer to operate, so the machine wouldn’t start any … Read more
A Kenmore washer at 8371 Walnut Street Southwest in Sherrodsville was leaking water underneath. The homeowner reported the water leaks underneath, and our diagnosis revealed an intermittent leak that appeared in two spots under the washer after it had been spinning for a while. The Problem The customer called because the water leaks underneath their … Read more
We received a call from Akron, OH about a Kenmore washer that does not complete the cycle. Our diagnostic revealed multiple fault codes pointing to control board failure, prompting us to recommend replacement over repair. The Problem The customer reported their Kenmore washer does not complete the cycle. They mentioned it won’t operate unless they … Read more
We responded to a service call in Homeworth, OH for a Speed Queen washer that filled up with water then it hums and won’t go to wash. Our diagnosis revealed a failed timer that we were able to temporarily repair by breaking loose corroded contacts. The Problem The customer reported that the washer filled up … Read more
A Canton homeowner contacted us about their Whirlpool washer that wasn’t operating properly. Our diagnosis revealed issues with the main control board and pressure sensor that required replacement to restore normal function. The Problem The customer reported their washer was experiencing operational problems that prevented normal washing cycles. The unit needed professional diagnosis to determine … Read more
A Maytag washer in Massillon started smoking during the final spin cycle and stopped working entirely. During the last wash, everything worked fine until the final spin — then there was noise, a cloud of smoke and no spinning. Our diagnosis revealed the issue required immediate attention to prevent further damage. The Problem The customer … Read more