KitchenAid Oven/Stove Repair (Model KERS505XSS03) – Louisville, OH
The KitchenAid stove had a non-working burner, and the exhaust hood needed new light bulbs. Both issues were resolved during the service.
The KitchenAid stove had a non-working burner, and the exhaust hood needed new light bulbs. Both issues were resolved during the service.
The bottom oven wouldn’t heat, and the top was intermittent. Replacing the ignitors resolved the issue.
A Maytag washer on Denver Drive in Youngstown stopped mid-cycle and wouldn’t drain, with a hot plastic smell developing. Our diagnosis revealed a motor overheating issue on this LAT9616AAE model, but unfortunately the motor is no longer available for replacement. The Problem The washer will start a load and half-way into the cycle it stops … Read more
A customer on West South Range Road in Alliance, OH called us about their Maytag washer not draining fully and clothes coming out soaking wet. After moving the unit upstairs, multiple fault codes had stored in the control system, pointing to various sensing errors. The Problem The customer reported their washer was not draining fully, … Read more
We responded to a service call in Mechanicstown for an NXR range that wasn’t heating properly. The customer reported the oven not heating well with a sporadic gas smell. Our diagnosis revealed a weak igniter that wasn’t drawing sufficient amperage to reliably open the gas valve. The Problem The customer complained that the oven was … Read more
A customer in Alliance contacted us for propane conversion on two dryers — a GE and an LG unit. They had the conversion kit for the LG and needed both units converted from natural gas to LP gas. The Problem The customer had a GE and LG dryer that needed converted to LP gas. They … Read more
We responded to a service call in Canton, OH for an LG washer that was powering on but the control panel would go blank and power off when choosing a cycle. The customer had already contacted LG support who walked them through a reset, but the washer lost power again mid-cycle with the same repeat … Read more
A Kenmore washer in Canton, OH stopped spinning during its cycle. The spin cycle stopped, leaving clothes soaking wet. Our diagnosis revealed a motor failure that made replacement the better option. The Problem The customer reported that the spin cycle stopped working on their Kenmore washer. The machine would fill and agitate normally but wouldn’t … Read more
The LG dryer was not heating despite turning on and spinning. A faulty high limit thermostat was replaced, restoring heat functionality.
The Maytag dryer wasn’t blowing air due to a cracked blower wheel. After replacing it, the dryer is now operating properly.