Samuel Willhite A Maytag dryer in Massillon wouldn’t start when the customer pressed the button. Our diagnosis revealed multiple failed heating system components that prevented normal operation. The Problem The customer reported that their dryer would not start. When they attempted to begin a cycle, the unit remained completely unresponsive. Diagnosis Testing revealed failures in multiple heating … Read more
A North Canton homeowner called about their Samsung dryer that had power but wouldn’t start when they hit the start button. They thought they heard a noise inside like whatever rotates the drum snapped. We found the belt had come off of the idler pulley. The Problem The customer reported their dryer has power but … Read more
A Canton homeowner called about their Maytag washer that would start sensing the load and then the light would go to done. After replacing the lid lock twice without success, we diagnosed capacitor failure with F5E3 and F7E1 error codes. The Problem The customer reported that the washer starts sensing the load and then the … Read more
A Whirlpool refrigerator on Northlawn Avenue NE in Louisville had a display that wouldn’t light up unless pushing buttons. We diagnosed the issue and replaced the main control board to restore normal operation. The Problem The customer reported that the display won’t light up unless pushing buttons. The refrigerator’s control panel remained dark during normal … Read more
A Canton homeowner called us about their Kenmore range overheating despite already replacing the temperature sensor. We found visible damage to the main control board and an F10 error code indicating the real culprit behind the persistent overheating issue. The Problem The customer reported their oven was overheating and running too hot. They had already … Read more
A Maytag dryer on Ohio Street in Alliance, OH was running but not drying clothes. We found the thermal fuse had blown, cutting off heat to the drum while allowing the motor to continue running. The Problem The customer reported their dryer runs but not drying. The unit would start and tumble clothes normally, but … Read more
A Whirlpool dryer on Smyth Avenue in Alliance, OH wouldn’t start — it powered on but wouldn’t spin. The customer had already diagnosed the issue and purchased a repair kit, knowing the belts were broken. The Problem The customer reported their dryer won’t start. It powers on but won’t spin, and they noted that belts … Read more
A KitchenAid dishwasher in Canton, OH was leaking water out of bottom front, with the homeowner suspecting the seal. What we found was actually a dislodged spray funnel on the top rack forcing water out the front door instead. The Problem The customer reported leaking water out of bottom front and thought it may be … Read more
We responded to a Samsung dryer service call in Bolivar, OH where the customer reported their unit runs but air is not heated. Our diagnostic found a failed heating element that needed replacement to restore proper operation. The Problem The customer contacted us because their Samsung dryer runs but air is not heated. The drum … Read more
A KitchenAid wall oven in Minerva was running temperatures that varied 25 to 50 degrees from the set point. The customer could set the temp for 350 and get 325 or 375, or set it for 450 and get 400. We found the oven control needed calibration adjustment. The Problem The customer reported that oven … Read more