GE Washer Repair (Model GTW460ASJ6WW) – Canton, OH
The washer wouldn’t drain, causing water to remain in the tub. A failed transmission was replaced to restore functionality.
The washer wouldn’t drain, causing water to remain in the tub. A failed transmission was replaced to restore functionality.
The dryer required the start button to be held down to run, which was fixed by correcting the wiring and replacing the front bearing kit.
A customer in Canton called about their GE refrigerator making abnormally loud fan motor sounds with vibration on the side. The evaporator fan was considerably louder than expected, and there had been one instance of the temperature reaching 60° with water on the floor. The Problem The customer noticed the evaporator fan was considerably louder … Read more
A Canton homeowner called about her older GE top-freezer refrigerator that had stopped cooling the bottom section properly. The freezer was staying cold, but the refrigerator compartment was warm. She suspected the evaporator fan motor had failed again, having had it replaced about 1.5–2 years ago. The Problem The customer reported that her refrigerator had … Read more
We responded to a service call on Lakewood Street Northwest in Canton, OH for a GE washer making loud screeching noise. Our diagnostic testing revealed no replicable issues with this GTW385ASWWS unit. The Problem The customer reported their GE washer was making loud screeching noise during operation. Diagnosis Screeching noise on several cycles. Unable to … Read more
A GE washer on Lakeside Drive in Akron was completely non-responsive with a lid lock failure and leaking underneath. Our diagnosis revealed multiple component failures, but we were able to get it running again with targeted repairs to the most critical systems. The Problem The customer reported their GE washer was non-responsive with lid lock … Read more
We completed a microwave installation on Belfort Avenue in Louisville, OH. The customer needed us to install their new microwave, and we got it mounted and ready to use. The Problem The customer purchased a new GE microwave and needed professional installation. They requested us to install the new microwave unit. Diagnosis This was a … Read more
A GE washer in Canal Fulton was experiencing multiple cycle issues — filling with water then immediately pumping out and shutting off during wash mode, plus draining without spinning in the drain cycle. Our diagnosis revealed a failed motor with a bad speed sensor requiring replacement. The Problem The customer reported that in wash mode, … Read more
A Paris, Ohio customer called with two appliances down — a newer GE washer that wouldn’t drain and an older Kenmore dryer that wouldn’t do anything. We found one simple winter problem and one failed safety component. The Problem The customer reported that the washer is newer and won’t drain. The older dryer, he said … Read more
A GE refrigerator in Waynesburg, OH wasn’t cooling properly because the freezer was building ice that blocked the fridge vents. Our diagnosis revealed a plugged defrost drain and a cracked defrost thermostat that needed replacement. The Problem The customer reported that the freezer was building ice, with ice blocking the fridge vents and not allowing … Read more