A KitchenAid dishwasher in Canton was having intermittent soap dispenser problems. The customer reported the dispenser doesn’t always open and it’s rather sporadic. Our diagnosis revealed a broken drawer slide was the culprit behind this frustrating issue. The Problem The customer’s dishwasher operates fine except for the soap dispenser doesn’t always open, it’s rather sporadic. … Read more
A Maytag dryer in Canton was squeaking when running, with the customer suspecting the idler wheel. We found the idler pulley had failed and was causing the noise during operation. The Problem The dryer squeaks when running, possibly idler wheel. Diagnosis Our inspection confirmed the idler pulley was the source of the squeaking noise. This … Read more
We responded to a washer repair call in Canton, Ohio for an Admiral washer that wouldn’t dispense water to start the cycle. The customer reported the cycle would count down but no washing was happening. Our diagnosis revealed an E56 error code pointing to a failed speed control board. The Problem The water will not … Read more
The oven heated unevenly due to weak igniters. Replaced the main oven burner igniters; ignition now in ~45 seconds and preheat in about 8 minutes.
The large burner on this GE range was heating poorly. Testing found the burner thermostat open; replacing the burner restored full, even heat.
The dryer developed loud tumbling noises from a frayed belt, worn idler/rollers, and a rock in the glides. Replacing those parts and clearing debris restored quiet operation.
Broiler appeared inoperative. Verified normal operation and showed correct broil settings; no parts needed.
A GE refrigerator in Canton, OH wasn’t maintaining proper temperatures — the fridge compartment wouldn’t go below 50 degrees. Our diagnosis revealed a failed fresh food recirculation fan and a plugged defrost drain that needed immediate attention. The Problem The customer reported that the temp in fridge won’t go below 50 degrees. This temperature issue … Read more
LG washer in Canton showed an OE drain error and wouldn’t rinse due to a failed drain pump. Replaced the pump; washer now drains and completes cycles.
We responded to a service call in Canton, OH for a GE washer that wasn’t completing wash cycles. The machine was not draining or spinning, leaving clothes soaked at the end of what should have been a complete wash. Our diagnosis revealed a failed drain pump assembly that needed replacement. The Problem The customer reported … Read more