Whirlpool Stove Repair (Model GGG388LXS00) – Green, OH
Whirlpool stove had stripped valve stems causing two burners to not shut off reliably. Replaced the front valve manifold (all four valves) to restore control.
Whirlpool stove had stripped valve stems causing two burners to not shut off reliably. Replaced the front valve manifold (all four valves) to restore control.
The oven heated unevenly due to weak igniters. Replaced the main oven burner igniters; ignition now in ~45 seconds and preheat in about 8 minutes.
The oven on this Frigidaire range wouldn’t heat due to a failed bake element. We confirmed 240V and replaced the element to restore baking.
The start relay failed, so the compressor wouldn’t start. Replacing the relay restored proper cooling and temperature control.
Dishwasher powered on but wouldn’t start. Main control board had 120V but no response; replacing the control restored normal operation.
Dryer ran and heated but made belt-slip noise. Failed idler pulley replaced and tested; unit operates quietly and normally.
The refrigerator’s water line was leaking. We cut out the damaged section and spliced new tubing to stop the leak.
Whirlpool washer WFW70HEBW0 was taking too long to finish. Cleared a clean-cycle error and secured a loose pressure hose rubbing the rotor to restore normal cycles.
The large burner on this GE range was heating poorly. Testing found the burner thermostat open; replacing the burner restored full, even heat.
Washer went out of balance during spin. We found weak shocks and a worn drive hub; recommended shock kit and hub replacement, but customer chose a new unit.