Samuel Willhite A Frigidaire wall oven on Highland Ave in Salem, OH was completely non-operational when we arrived. After diagnosis, we found the main relay board had failed, cutting power to both oven cavities. The Problem The customer reported their wall oven was non operational. Neither oven cavity would heat or respond to controls. Diagnosis Testing revealed … Read more
A Maytag washer in Carrollton, OH wasn’t draining properly, leaving clothes soaked at the end of cycles. During our inspection, we discovered the transmission splines were worn, which caused the hub to strip. The Problem The customer reported that clothes are soaked when done. The washer was not draining the water out when it finished … Read more
A Frigidaire dryer in Carrollton was making a very loud noise when running, and the homeowner suspected bad bearings. Our diagnosis confirmed worn drum support components that needed replacement with a complete maintenance kit. The Problem The customer reported that their Frigidaire dryer was making a very loud noise when running. They suspected the bearings … Read more
A Whirlpool oven in Kensington, OH wouldn’t heat at all. The customer called ahead to let us know about the issue. We found the bake element had failed completely. The Problem The customer reported their oven won’t heat. The unit would turn on but produced no heat for baking or cooking. Diagnosis We tested the … Read more
We responded to a service call in Canton, OH for a commercial Whirlpool coin-op washer that wasn’t cycling well. Upon inspection, we discovered the balance ring had worked loose on the washer tub, causing the operational issues. The Problem The customer reported that the washer isn’t cycling well. This type of issue in commercial coin-operated … Read more
The dishwasher wouldn’t drain due to a plugged fitting and a siphoning issue. After clearing the obstruction and adjusting the hose, it’s now working fine.
The oven failed to heat to the requested temperature and often shut off. Replacing the igniter resolved the issue.
The refrigerator was not cooling due to a frosted-up freezer. Replacing the heating element for defrost resolved the issue.
The washer failed to drain due to an F9 E1 error. Replacing the drain pump, pressure sensor, and control board resolved the issue.
The front right burner stopped working while the other burners were fine. Replacing the surface element resolved the issue.