Samuel Willhite We repaired a Whirlpool coin-operated top load washer in Navarre that wouldn’t drain. The owner called because the machine was filling but not emptying after wash cycles. Our diagnosis revealed a kinked drain line preventing proper drainage, plus a failing cold water valve. The Problem The coin operated top load washer won’t drain. This commercial-style … Read more
A Whirlpool washer at 915 Meese Road Northeast in Louisville was showing an SD code and would not finish its cycle. Our diagnostic revealed major internal damage that made replacement the most practical choice. The Problem The customer reported their washer was displaying an SD code and would not finish the wash cycle. The machine … Read more
A customer in Minerva called about her Whirlpool washer not going through all of cycle and dripping water in machine. When we arrived to diagnose the WTW4850XQ0, we cleaned the screens but couldn’t really find anything wrong with the washer. The Problem The washer wasn’t completing its full wash cycle and had water dripping inside … Read more
A commercial washer repair call in Canton, OH led to an unfortunate but honest assessment. The commercial washer was out of order, and our diagnosis revealed the unit was too old to get parts. The Problem The customer reported their commercial washer was out of order. This Whirlpool coin-operated unit had stopped functioning entirely. Diagnosis … Read more
A Samsung oven in Canton wasn’t igniting properly and the homeowners sometimes smelled gas. We found the bake ignitor had failed and replaced it with a factory part. The Problem The customer reported their oven doesn’t ignite properly and sometimes they smell gas. This is a concerning combination that requires immediate attention for safety reasons. … Read more
A Salem homeowner called us after their contractor replaced their sink and their Admiral dishwasher stopped working. The unit would run for a few minutes and then error out. Our diagnosis revealed a simple but critical oversight from the installation work. The Problem The customer reported that after having a contractor replace their sink, their … Read more
A KitchenAid oven in Canton wasn’t heating properly despite showing it was preheating. The lower oven said preheating however never gets hot. Our diagnosis revealed a failed lower bake igniter that needed replacement. The Problem The customer reported that their lower oven says preheating however never gets hot. The display indicated the unit was attempting … Read more
We completed a gas oven repair in Canton, OH for a customer whose GE oven would turn on to heat up but wouldn’t reach the set temperature and would begin to lose heat. Our diagnosis revealed the oven bake igniter was out of specs and needed replacement. The Problem The customer reported their gas oven … Read more
We responded to a dual appliance service call in North Canton for a Frigidaire combination unit experiencing both oven and ice maker issues. The customer reported that the oven would not preheat on bake but would on broil, plus an ice maker leak in the freezer. Our diagnosis revealed a failed oven ignitor as the … Read more
A customer in Dellroy called about their Whirlpool refrigerator that was freezing food and liquids even at the recommended temperature setting. When we arrived, the issue had already resolved itself after the customer unplugged and reset the unit. The Problem At recommend setting 4 of 7, food and liquids were freezing on shelves and in … Read more