A Maytag washer on Denver Drive in Youngstown stopped mid-cycle and wouldn’t drain, with a hot plastic smell developing. Our diagnosis revealed a motor overheating issue on this LAT9616AAE model, but unfortunately the motor is no longer available for replacement. The Problem The washer will start a load and half-way into the cycle it stops … Read more
A customer on West South Range Road in Alliance, OH called us about their Maytag washer not draining fully and clothes coming out soaking wet. After moving the unit upstairs, multiple fault codes had stored in the control system, pointing to various sensing errors. The Problem The customer reported their washer was not draining fully, … Read more
We responded to a service call in Canton, OH for an LG washer that was powering on but the control panel would go blank and power off when choosing a cycle. The customer had already contacted LG support who walked them through a reset, but the washer lost power again mid-cycle with the same repeat … Read more
A Kenmore washer in Canton, OH stopped spinning during its cycle. The spin cycle stopped, leaving clothes soaking wet. Our diagnosis revealed a motor failure that made replacement the better option. The Problem The customer reported that the spin cycle stopped working on their Kenmore washer. The machine would fill and agitate normally but wouldn’t … Read more
The washer was slow to drain and hesitant to cycle, leading to a clogged pump issue. The repair involved replacing the shift actuator and cleaning inlet screens.
The washer wasn’t turning on due to a tripped GFCI plug. After resetting, it ran smoothly, but a replacement is recommended.
The washer failed to drain and spin due to a faulty lid switch, which was replaced to restore functionality.
A Kenmore washer in North Canton was displaying an F25 code and wouldn’t complete its cycle. Our diagnosis revealed a failed motor control board causing the tachometer reading issues. The Problem The customer reported an F25 code appearing on the machine and the washer won’t complete the cycle. This error code typically indicates communication problems … Read more
The washer wouldn’t spin and displayed a ‘sensing load’ error. After replacing the actuator and cleaning the inlet filter, it now runs smoothly.
The washing machine buzzed instead of starting due to a rusty top panel. Replacing it resolved the issue.