A homeowner in Massillon called about their Whirlpool dryer that will not turn on. The unit began needing to be restarted 3-4 times to dry a load and now will not start at all, despite being only 1.5 years old. The Problem The customer reported their dryer will not turn on. It began needing to … Read more
A Whirlpool dryer on East Line Street in Minerva, OH kept fraying belts around a pulley despite the homeowner replacing the drum belt twice. The original belt had snapped, and subsequent replacements continued to fray in the same spot, pointing to a worn idler pulley causing the damage. The Problem The customer had replaced the … Read more
A Whirlpool washer in Carrollton, OH would not go past spin cycle. The customer reported the machine was getting stuck at this stage of the wash process. Our diagnosis revealed a lid lock error that was preventing normal operation. The Problem The Whirlpool washer will not go past spin cycle. The machine was stopping at … Read more
A Whirlpool dishwasher on Ray Avenue in Carrollton was leaking water from underneath across the floor. Our diagnosis revealed the upper spray arm was caught and spraying on the door seal, with both upper and lower spray arms split and damaged. The Problem The customer reported their Whirlpool dishwasher leaking water from underneath across floor. … Read more
A Whirlpool refrigerator in Hartville had both freezer drawers that fell apart, leaving the customer using just one drawer. Our diagnosis revealed the bottom drawer wasn’t installed correctly and the top drawer needed complete replacement. The Problem The customer reported they need both freezer drawers fixed because they fell apart and were currently using one … Read more
A Whirlpool washer in Navarre, OH had a blinking lock light and wouldn’t start because it wouldn’t lock properly. We found the lid latch had failed and replaced it to restore normal operation. The Problem The customer reported their Whirlpool washer had a blinking lock light and the washer wouldn’t lock, preventing it from starting. … Read more
Whirlpool stove had stripped valve stems causing two burners to not shut off reliably. Replaced the front valve manifold (all four valves) to restore control.
A Whirlpool dishwasher in Canton, OH wasn’t drying dishes properly, with the customer reporting a bad heating element. Our diagnostic revealed the unit just needed error codes cleared to restore normal operation. The Problem The customer called about their Whirlpool dishwasher because dishes were not drying after wash cycles. They suspected the heating element had … Read more
We serviced a Whirlpool washer in Atwater that wouldn’t drain or spin, with the control board appearing unresponsive. The customer reported the washer filled up with water but couldn’t complete its cycle. The Problem The washer filled up with water but would not drain or spin, and the washer board seemed to be unresponsive. The … Read more
A Salem homeowner contacted us after discovering their newly repaired dishwasher was leaking and had flooded the kitchen floor area and basement ceiling area. After running a load of dishes, they noticed heavy dripping from the basement ceiling directly under the dishwasher and found the floor area waterlogged. We found the drain pump was not … Read more