We responded to a service call on Captens Street NE in Canton, OH for a GE washer that wouldn’t agitate during wash cycle or spin during spin cycle. Our diagnosis revealed multiple interconnected issues with the transmission and drive system that required comprehensive repair. The Problem The customer reported their GE washer won’t agitate during … Read more
We were called to Edmar Street in Louisville, OH for a GE washer making loud noise and refusing to spin or drain. The customer had already tried replacing suspension rods and checking hoses. When we opened it up, we discovered the drum base was broken — a fatal failure that meant this washer was done. … Read more
A customer on Burke Ave NE in Louisville called about their GE top-load washer that was not spinning properly and leaving small black debris inside the tub. What we found was a unit with multiple failing systems that made replacement the better choice. The Problem The customer reported that their GE top-load washer was not … Read more
We responded to a North Canton home where a GE dryer was getting very hot in the back and wouldn’t run. The customer reported hitting the button resulted in just a whirring sound, and they’d already had the vent professionally cleaned with no improvement. The Problem Gets very hot in the back and will not … Read more
A GE refrigerator on Kennedy Street in Louisville, OH wasn’t cooling despite the customer vacuuming out the back three months prior. We found the compressor running but overheating with no cooling in either the fridge or freezer compartments. The Problem The customer reported the refrigerator says it’s satisfied but won’t seem to cool. They had … Read more
Water was leaking inside the refrigerator compartment. Clearing a clogged freezer defrost drain restored proper drainage and stopped the leak.
The GE washer wasn’t filling and was throwing errors. Cleaning the water inlet screens and the drive belt restored normal operation.
A customer in Carrollton, OH called because their GE refrigerator and freezer wouldn’t hold temp. We diagnosed a failed evaporator fan in the freezer compartment and replaced it to restore proper cooling. The Problem The customer reported that their refrigerator and freezer won’t hold temp. Both compartments were running warm despite the compressor cycling normally. … Read more
A GE dryer on Blackburn Road Northwest in Canton wasn’t closing properly and running louder than normal. We found a lint trap that was completely plugged and a blower wheel obstructed with debris. The Problem The customer reported that the door doesn’t close well and the dryer is louder than usual. These symptoms often point … Read more
A GE microwave in Malvern, OH had completely lost power and wouldn’t respond to any controls. We discovered a wire with a bad connection where it connected to the thermal fuse — a factory defect that finally caused complete failure. The Problem The customer reported their microwave lost power entirely. No display, no response from … Read more