A Samsung top-load washer at a home on Prospect Avenue in Canton, OH wasn’t spinning out clothes properly. The unit would pump out water but leave clothes soaking wet after the spin cycle. Our inspection revealed structural damage that explained the spinning issue. The Problem The customer reported their Samsung washer was not spinning, though … Read more
A customer in Navarre called about their Amana washer that wouldn’t fill or rinse. When we opened up the machine, we found the water inlet valve had failed completely, cutting off water flow to the tub. The Problem The customer reported their washer wont fill and wont rinse. The machine would start its cycle but … Read more
We responded to a service call in North Canton for an LG washer that was smoking during the spin cycle. What we discovered was significant structural damage that made repair impractical for this particular unit. The Problem The customer reported their washer smokes during spin cycle. This is always a serious symptom that requires immediate … Read more
A customer in Malvern called about their Amana washer that wouldn’t stop filling with cold water. The cold water continued even when it fills up and only stopped when you turn the water supply off. We found a failed water valve that needed replacement. The Problem The customer reported that cold water continues even when … Read more
We responded to a service call on Mc Call Road in Garrettsville, OH for a Whirlpool washer with an agitator not working. What appeared to be a mechanical failure turned out to be a water supply issue affecting the entire home’s plumbing system. The Problem The customer reported that the agitator was not working on … Read more
A Canton homeowner called because their Whirlpool washer would fill and drain but would not agitate. Our diagnosis revealed two failed components that prevented the machine from properly washing clothes during the wash cycle. The Problem The washer will fill and drain but will not agitate. The machine would go through its cycles and drain … Read more
We were called to Edmar Street in Louisville, OH for a GE washer making loud noise and refusing to spin or drain. The customer had already tried replacing suspension rods and checking hoses. When we opened it up, we discovered the drum base was broken — a fatal failure that meant this washer was done. … Read more
A customer on Burke Ave NE in Louisville called about their GE top-load washer that was not spinning properly and leaving small black debris inside the tub. What we found was a unit with multiple failing systems that made replacement the better choice. The Problem The customer reported that their GE top-load washer was not … Read more
Washer showed F20 due to a failed inlet flow meter that couldn’t confirm water supply. Replaced the flow meter sensor and restored normal operation.
Washer filled and washed but would not drain or spin. A failed lid switch was replaced to restore normal operation.