A Maytag washer on Chadsworth Avenue in Louisville went completely dead overnight during a wash cycle, leaving the customer with wet laundry and no power to the unit. Despite trying basic troubleshooting steps, the washer remained unresponsive. Our diagnosis revealed a failed control board that would require replacement along with potentially other components. The Problem … Read more
A Maytag washer at a home on Diamond Street NE in Canton was just quitting mid cycle. When we diagnosed the machine, we found the wash plate and transmission were bad — a major repair that the customer chose not to pursue. The Problem The customer reported their Maytag washer was just quitting mid cycle. … Read more
A Canton homeowner called about their Maytag washer that just flashes error messages and will not start cycle. Even unplugging the washer to reset it does not work — it just starts running through all of the error messages again. Water damage on the main control board from a backed up drain had taken out … Read more
We received a service call for an LG washer in Navarre, OH with a complaint of not washing properly. Upon arrival, our technician found the machine was cycling properly, but the customer declined to proceed with service. The Problem The customer reported their LG washer was not washing properly and scheduled a diagnostic appointment. Diagnosis … Read more
A Maytag washer in Canton was showing a SUD error and wouldn’t drain. The homeowner called us when their laundry routine came to a halt with standing water in the tub. The Problem The customer reported their washer was displaying a SUD error code and would not drain water from the drum. This left clothes … Read more
A Samsung front load washer in Hartville, OH wasn’t spinning correctly and appeared to have a loose drum. The customer could see the drum wasn’t spinning smoothly and suspected it was out of balance, though it wasn’t actually unbalanced. Our diagnosis revealed a broken spider/drum support assembly. The Problem The customer reported that their Samsung … Read more
A Samsung washer in Canton was throwing 4C and 0C error codes despite being only 4½ years old. The customer mentioned the unit had given trouble on and off since new. We found a clogged pressure tube causing the false water level readings. The Problem The washer kept giving 4C or 0C codes and had … Read more
A Maytag washer in Carrollton, OH wasn’t draining properly, leaving clothes soaked at the end of cycles. During our inspection, we discovered the transmission splines were worn, which caused the hub to strip. The Problem The customer reported that clothes are soaked when done. The washer was not draining the water out when it finished … Read more
We responded to a service call in Canton, OH for a commercial Whirlpool coin-op washer that wasn’t cycling well. Upon inspection, we discovered the balance ring had worked loose on the washer tub, causing the operational issues. The Problem The customer reported that the washer isn’t cycling well. This type of issue in commercial coin-operated … Read more
The washing machine wouldn’t start and just buzzed. Replacing the faulty capacitor on the motor resolved the issue.