A customer in Alliance, OH called about their Whirlpool washer that wouldn’t complete cycles properly. The washer would wash and drain but then blink on the wash cycle without spinning, forcing the customer to wring out clothes by hand. Our diagnosis revealed a faulty lid lock assembly triggering an F5E1 error code. The Problem The … Read more
A Whirlpool washer in Canton, OH wouldn’t fill up when the lid is locked. Our diagnostic revealed multiple error codes pointing to main control board failure, though additional mechanical issues couldn’t be ruled out due to the electrical problems. The Problem The customer reported that their Whirlpool washer won’t fill up when the lid is … Read more
A washer repair call in Canton brought us to a 2019 LG front-load washer with water leaking from the bottom. The customer reported water pooling underneath the unit during wash cycles. Our diagnosis revealed a split cold water fill hose shooting water directly into the cabinet. The Problem Water is leaking from the bottom of … Read more
We serviced a Whirlpool washer in Diamond, OH that had the door locked, wouldn’t drain, and was making a buzzing sound. Our technician found a broken drill bit jammed in the pump impeller, preventing it from spinning properly. The Problem The customer reported that the door was locked, the washer wouldn’t drain, and something was … Read more
A Kenmore washer in Massillon was leaving clothes still wet at the end of the cycle. Our diagnostic revealed the bearings slash transmission are failing, making this a costly repair on an older unit. The Problem The customer reported that clothes are still wet at the end of the cycle. This symptom typically indicates the … Read more
A Maytag washer in Canton, OH wouldn’t start and had a blinking lid lock light. After diagnosing the unit, we found multiple major components had failed, making repair uneconomical. The Problem The customer reported that the cycle does not start and the lid lock light blinks. This typically indicates either a lid lock issue or … Read more
A Samsung washer in Canton stopped spinning with a burning smell and bits of melted rubber in the drum. The customer suspected a burnt belt, but our diagnosis revealed a much more serious structural problem. The Problem The Samsung washer stopped spinning and produced a burning smell. Bits of melted rubber were present in the … Read more
We recently completed a washer repair on Woodrow Street Northwest in North Canton, OH. The customer’s LG washer was not draining and showing an OE error message. After checking hoses and drain filter with no blockage found, the issue turned out to be a failed drain pump. The Problem The customer reported their LG washer … Read more
A customer in Alliance called about their Admiral washer making a loud noise during the agitation cycle. When the washer aggitates it makes a loud noise. We found the washer was rubbing on the pallet underneath it. The Problem The customer reported that when the washer aggitates it makes a loud noise. This was happening … Read more
A Kenmore washer in North Canton wasn’t draining or spinning, leaving water sitting in the tub after wash cycles. The machine would fill and wash normally, but stopped functioning during the drain and spin phases. We diagnosed a failed lid switch that was preventing the washer from advancing through its full cycle. The Problem The … Read more