Samuel Willhite A Louisville homeowner called with their Maytag Bravo top loader stuck mid-cycle. The tub was full of water, the lid was locked and wouldn’t unlock, and the washer wouldn’t run or drain. We found a failed control board that needed replacement. The Problem The customer reported their washer had a tub full of water with … Read more
A KitchenAid refrigerator in Canton wasn’t cooling properly, leaving the homeowner concerned about food safety. Our diagnostic revealed a known technical service bulletin issue affecting this model’s frost control system. The Problem The customer reported their fridge was not cooling properly. This is a critical issue that requires immediate attention to prevent food spoilage and … Read more
A Maytag dryer in North Canton started squeaking occasionally before stopping mid-cycle and refusing to start at all. Our diagnosis revealed a failed idler pulley that needed immediate replacement. The Problem The customer reported their garage dryer was starting to squeak a little once in a while. Then it stopped in the middle of a … Read more
A homeowner in North Canton called us when part of a robe tie got stuck under the agitator in their Whirlpool washer. The machine wouldn’t operate properly with the fabric obstruction, and they couldn’t retrieve it themselves. The Problem Part of a robe tie was stuck under the agitator. The fabric had worked its way … Read more
We responded to a service call in North Canton for an LG washer that had a ripped ring and was leaking water. Our diagnosis revealed two failed components that required replacement to stop the leak and restore proper operation. The Problem The customer reported that the ring is ripped and it’s leaking water. This combination … Read more
A Kenmore refrigerator in Massillon wasn’t keeping the refrigerator compartment cold enough, running at 52 degrees when it should have been much colder. The freezer seemed fine, but the main compartment temperature had been climbing over several days. We found the issue was a failed motor fan assembly in the freezer compartment. The Problem The … Read more
We responded to a Kenmore dryer repair call in North Canton, OH where the customer reported their unit was not heating. They had already verified gas was on at the house and confirmed the lint screen and vent outlet were clear. Our diagnostic revealed failed thermal fuse and gas coil packs preventing proper heating operation. … Read more
A Samsung washer in North Canton wasn’t starting because the door wouldn’t lock properly. After diagnosing the door latch assembly, we found it needed to be reinstalled to restore proper operation. The Problem The customer reported that the door will not lock. This prevented the washer from starting its wash cycle, as Samsung washers require … Read more
A customer in Akron called about their Whirlpool refrigerator that does not dispense cubes it makes through the door. When we inspected the WRS571CIDB01, we found the wire harness had a broken wire at the bottom of the door causing the dispensing failure. The Problem The customer reported that their Whirlpool refrigerator does not dispense … Read more
A Samsung washer and dryer set in Uniontown needed attention when the dryer belt broke and the washer developed severe shaking during high spin cycles. What we found was a straightforward dryer repair, but a more serious structural problem with the washer. The Problem The customer reported that the dryer belt broke and needed replaced, … Read more