Samuel Willhite A customer in Sherrodsville called about their Kenmore washer that wasn’t responding to any controls. The washer did nothing when you push, pull or twist the knob, while their dryer operated fine. Our diagnosis revealed a failed timer that needed replacement. The Problem The customer reported that their washer does nothing when you push, pull … Read more
We completed a dual appliance repair in Alliance, OH this week — a Whirlpool washer with a hot water intake valve issue and a Hotpoint dryer that wouldn’t stay running without holding the start button. Both problems required straightforward part replacements to restore normal operation. The Problem The customer reported that the hot intake on … Read more
A Maytag washer in Canton, OH was suddenly extremely loud when spinning. Our diagnosis revealed failed bearings that would require transmission replacement on this model, making repair uneconomical. The Problem The customer reported their Maytag washer was suddenly extremely loud when spinning. This type of noise issue typically indicates mechanical failure in the drive system. … Read more
A GE oven at a home on Aebi Avenue in Alliance, OH wouldn’t stop heating up when shut off and was displaying an F2 error code. Our diagnostic revealed a control board malfunction that would require significant repair investment on this older unit. The Problem The customer reported their GE oven wont stop heating up … Read more
A customer in Canton called about their Tappan stove — the right front burner doesn’t work. We found a failed surface element that needed replacement. The Problem The customer reported that their right front burner doesn’t work. The burner would not heat up when turned on. Diagnosis Testing revealed the surface element had failed and … Read more
We responded to a commercial kitchen in Massillon for an Admiral exhaust hood with no power going through the switch to the unit. The data plate was faded very bad and couldn’t be read, but our diagnosis revealed the issue wasn’t with the hood itself. The Problem The customer reported no power going through switch … Read more
We received a service call in Minerva, OH for an Amana refrigerator that wasn’t cooling well, with the customer hearing the relay clicking on and off. Our diagnosis revealed a failed compressor with locked rotor amp draw measuring 17 amps while pulling 22 amps during operation. The Problem The customer reported that their refrigerator wasn’t … Read more
A Samsung refrigerator in Malvern, OH wasn’t keeping food cold while the freezer worked fine. We found multiple issues including a plugged defrost drain that required several components to restore proper cooling. The Problem The customer reported their refrigerator was not cold while the freezer was working normally. This temperature imbalance typically points to airflow … Read more
A Maytag refrigerator in Homeworth, OH was getting all ice and frost on the inside. The customer suspected the door seal, but we discovered the real culprit was a door alignment issue preventing proper closure. The Problem The customer reported that their refrigerator gets all ice/frost on the inside and thought it may be the … Read more
We responded to a service call on McCallum Ave NE in Alliance, OH for a Whirlpool refrigerator that wasn’t cooling well in the freezer. When we arrived, the fridge was operating properly at the time of service. The Problem The customer reported that their Whirlpool refrigerator was not cooling well in the freezer compartment. Diagnosis … Read more