Whirlpool Refrigerator Repair (Model ED5FVGXSS03) – Alliance, OH
Refrigerator cooled sporadically due to a failing cold control thermostat. Replaced the thermostat and cooling is now consistent.
Refrigerator cooled sporadically due to a failing cold control thermostat. Replaced the thermostat and cooling is now consistent.
This Whirlpool dryer in Alliance wasn’t heating even though it ran. Replacing a blown high-limit fuse, cycling thermostat, and warped heater restored heat.
The dryer had no heat due to a failed heating element. Installing a new element restored proper cycling and heat.
The cold control thermostat failed, causing intermittent cooling. Replacing the thermostat restored consistent temperature.
The Whirlpool dishwasher was not cleaning due to a clogged middle spray arm. We cleared the blockage and restored proper spray and wash performance.
Alliance homeowner reported a freezer not defrosting. We tested the defrost system; no fault found during the visit and the unit operated normally.
A Magnolia homeowner called about their Whirlpool washer that wouldn’t lock the lid or spin. When our technician arrived at the scheduled appointment, another service company was already there working on the machine. The Problem The customer reported that the lid won’t lock and the washer won’t spin. This combination typically indicates an issue with … Read more
A Whirlpool washer in Alliance, OH was really loud when it came to a stop, with the front left edge banging into the dryer. Our diagnosis revealed the brake and clutch assembly had failed, requiring complete replacement to restore normal operation. The Problem The customer reported their washer was really loud when it came to … Read more
A Louisville homeowner called us about their Whirlpool dishwasher that had standing water in it and would not wash well. When they pressed the cancel button it would not drain. Our diagnosis revealed multiple component failures that were preventing proper operation. The Problem The customer reported that their dishwasher had standing water in it and … Read more
A Whirlpool washer on W 1st St in Minerva was running through cycles but then stopping with a spinning noise without actually spinning. The unit required unplugging to reset, and we diagnosed a failed control board throwing an F3E1 error. The Problem The customer reported their unit runs through cycle, then stops. It makes spinning … Read more