We completed a dishwasher installation in Atwater, OH for a customer who had received a used Whirlpool dishwasher. The unit needed a power cord and drain hose connection to get it running in their kitchen. The Problem The customer contacted us because they needed power cord and drain hose connections for their dishwasher. They had … Read more
A Canton homeowner called about their Whirlpool Ultimate Care 2 washer that was not spinning and making noise during the spin cycle. When we arrived, we found the motor coupling had failed — a common issue on this model that prevents the washer from completing its spin cycle properly. The Problem The customer reported that … Read more
Washer door was stuck locked with E2/F3 errors. Repaired broken temperature sensor harness and replaced the drain pump to restore normal operation.
This Whirlpool washer left loads soaking wet due to a stripped drive hub. We replaced the hub and restored spin; a transmission may be needed if it recurs.
A Whirlpool Duet washer in Louisville was pulling F7 E8 error codes and wouldn’t spin or run. When we arrived, we found the homeowner had already attempted to diagnose the problem and partially disassembled the unit. The pressure sensor hose had rubbed against the stator and developed a hole, causing the washer to go into … Read more
A Tallmadge customer called about their Whirlpool washer’s spin cycle not working, making weird droning noise and thumping like the load was uneven. We found the hub had stripped, causing the wash plate to lose connection and creating the noise and balance issues. The Problem The spin cycle is not working. It makes weird droning … Read more
A Charleston Drive homeowner in Akron called about their 5-6 year old Whirlpool range with burner control issues. Two burner knobs weren’t turning off properly and felt stripped when turning. Our diagnosis revealed stripped valve stems in the front manifold assembly. The Problem Two burner knobs and shafts were stripped or not turning off properly. … Read more
Dryer squeaked and rumbled due to worn support rollers and idler pulley. Installed Whirlpool kit with new rollers, idler, and belt to restore quiet operation.
A Whirlpool refrigerator in Uniontown stopped making ice completely. After multiple service visits over several months, we traced the root cause to a failed fill tube heater that required replacing the entire door assembly. The Problem The customer reported that the ice maker was no longer making ice. This was actually a recurring issue that … Read more
A Whirlpool oven on Brook Run Avenue Northeast in Louisville wasn’t responding to bake commands properly. When turning on the oven to bake, it instead turns on the broiler. Our diagnosis revealed a failed control board that needed replacement. The Problem The customer reported that when turning on the oven to bake, it instead turns … Read more