A Charleston Drive homeowner in Akron called about their 5-6 year old Whirlpool range with burner control issues. Two burner knobs weren’t turning off properly and felt stripped when turning. Our diagnosis revealed stripped valve stems in the front manifold assembly. The Problem Two burner knobs and shafts were stripped or not turning off properly. … Read more
Dryer squeaked and rumbled due to worn support rollers and idler pulley. Installed Whirlpool kit with new rollers, idler, and belt to restore quiet operation.
A Whirlpool refrigerator in Uniontown stopped making ice completely. After multiple service visits over several months, we traced the root cause to a failed fill tube heater that required replacing the entire door assembly. The Problem The customer reported that the ice maker was no longer making ice. This was actually a recurring issue that … Read more
A Whirlpool oven on Brook Run Avenue Northeast in Louisville wasn’t responding to bake commands properly. When turning on the oven to bake, it instead turns on the broiler. Our diagnosis revealed a failed control board that needed replacement. The Problem The customer reported that when turning on the oven to bake, it instead turns … Read more
This Whirlpool dryer was running but not heating due to a failed heating element. Replacing the element restored proper drying.
Whirlpool refrigerator GI6SARXXF06 had a seeping water inlet valve that froze the ice maker fill. Replaced the valve and cleared the line to restore ice.
This Whirlpool dryer wasn’t drying due to a failed timer causing intermittent heat. Replacing the timer restored consistent heat and normal drying.
The ice maker was dripping during fill and freezing into a solid block. Replacing the ice maker assembly restored normal ice production.
The refrigerator stopped making ice due to a non-cycling ice maker. Replacing the ice maker restored normal ice production.
A Whirlpool dishwasher on Maplegrove Street in Louisville wouldn’t latch properly and refused to start. The customer was convinced the door latch had failed, but when I pulled the unit out to check the mechanism, I found the real problem was much simpler — a loose mounting screw had thrown off the door alignment. The … Read more