A Samsung dryer in Canton, OH wouldn’t dry clothes properly. The customer called because their dryer was running but not producing heat or drying effectively. We found two failed components causing the heating system to shut down. The Problem The customer reported their Samsung dryer won’t dry. The unit would run through cycles but clothes … Read more
A Whirlpool dryer in North Canton was making a screeching and squealing noise when operating. We found clothes wrapped around the blower motor that were causing the noise and preventing proper operation. The Problem The customer reported their dryer was making a screeching/squealing noise when operating. This type of noise typically indicates something is interfering … Read more
We got a service call for an LG dryer in Canton that wasn’t heating up. When we arrived at the 22nd Street Northwest address, we discovered the gas dryer wasn’t hooked up to any gas line at all. The Problem The customer reported their LG dryer was not heating up. The unit would run through … Read more
A Maytag dryer at a home on Shunk Avenue in Alliance, OH was turning on and spinning but would not dry clothes. Our diagnosis revealed a faulty high limit thermal fuse that had cut power to the heating element. The Problem The customer reported their dryer turns on and spins but will not dry clothes. … Read more
A Frigidaire dryer in Massillon was getting too hot and melting clothes. Our diagnosis revealed failed temperature control components that were allowing the dryer to overheat beyond safe operating limits. The Problem The customer reported that the dryer is getting too hot and melting clothes. This is a serious safety issue that indicates the temperature … Read more
We responded to a service call in Minerva for an Admiral dryer that was spinning but not heating. After checking the dryer thoroughly, we discovered the issue wasn’t with the appliance at all — a faulty circuit breaker in the mobile home was cutting power to the heating element. The Problem The customer reported their … Read more
A Frigidaire dryer in Minerva was acting erratically — it wouldn’t shut off and would only dry on the 15-minute timer setting while a set of lights kept blinking. We found the control board had failed and was sending incorrect signals throughout the system. The Problem The customer reported their dryer was hard to describe … Read more
A Samsung dryer at a home on South Seneca Avenue in Alliance, OH was turning on but wouldn’t tumble. We diagnosed a failed idler pulley and replaced it to restore normal operation. The Problem The customer reported that their dryer turns on but will not tumble. The unit would power up and run through cycles, … Read more
A Samsung dryer in Canton, OH wasn’t drying clothes properly despite having a heating element replaced just six months earlier. The homeowner was frustrated after spending money on a recent repair that didn’t seem to last. Sometimes the simplest issues can masquerade as major problems. The Problem The customer reported their dryer won’t dry, even … Read more
A Whirlpool dryer in Salem, OH was running but wouldn’t spin, leaving clothes wet after full cycles. Our technician found multiple drum support components had worn out, requiring a comprehensive repair to restore proper tumbling action. The Problem The customer reported their dryer runs but won’t spin. The unit would start and run through its … Read more