We recently serviced an Admiral oven on McKimm Avenue in Louisville, OH that wouldn’t heat past 185 degrees. The homeowner couldn’t get their oven to reach proper cooking temperatures, making meal preparation nearly impossible. The Problem The customer reported that their oven won’t heat past 185 degrees. This temperature limitation meant the oven was essentially … Read more
A homeowner on Meese Rd NE in Louisville called about a Pellpro PP60 pellet stove that wouldn’t power up or begin startup. The status light was flashing steadily at one-second intervals whether the control knob was turned on or off, and the customer was unsure of the proper startup procedure. The Problem Customer called about … Read more
A Louisville homeowner called us about their Whirlpool washer that wasn’t spinning clothes dry. The laundry was coming out still wet after the spin cycle. Our diagnosis revealed worn splines on the shaft that needed immediate attention. The Problem The washer was not spinning clothes dry, leaving laundry still wet at the end of the … Read more
Washer went out of balance during spin. We found weak shocks and a worn drive hub; recommended shock kit and hub replacement, but customer chose a new unit.
The stove would not power up or feed pellets due to a failed control potentiometer interface. We installed a new control board and cleared an auger jam, restoring normal operation.
Plugged into 220V, this refrigerator would not power on. Diagnosis found a fried inverter board; advised inverter board replacement under warranty.
Washer lid would not lock and water dripped into the tub when off. Replaced a failed lid switch and a faulty water inlet valve to restore normal use.
Dryer powered on but wouldn’t start. A failed door switch was replaced to restore operation.
GE dryer in Louisville, OH was loud while tumbling. Replaced worn front upper bearing assembly to restore quiet, smooth operation.
A Louisville homeowner contacted us when their GE dishwasher’s soap compartment stopped opening reliably during wash cycles. The spring mechanism was malfunctioning, leaving dishes with a cloudy residue that required re-rinsing and drying. The Problem The soap compartment would not open and release soap during a wash cycle. The spring seemed to malfunction most times … Read more