A Maytag Bravos MCT washer in Minerva, OH wasn’t spinning clothes out properly, leaving them dripping wet after cycles. We found the transmission hub on the basket had stripped out completely. Due to corrosion on the transmission shaft, this repair may be temporary. The Problem The customer reported that the washer doesn’t spin the clothes … Read more
Noisy operation traced to worn idler pulley and support roller. Replaced pulley and one roller and cleaned lint to restore smooth, quiet drying.
This Maytag washer would spin but not agitate due to a stripped wash plate and worn hub. Replacing both restored proper wash action.
Dryer would only run when the dial was held and shut off at random. Replacing a failed timer restored consistent, hands-free operation.
A Maytag dishwasher in East Rochester wasn’t cleaning dishes despite running through all cycles. The customer could hear water start but the wash arms weren’t rotating, and soap remained in the dispenser. Our diagnosis revealed a broken food grinder that had locked up the entire pump assembly. The Problem The customer reported they could hear … Read more
A Maytag washer in Canton, OH was displaying F9E1 error code and draining water unexpectedly. The customer reported that it started draining the water out right before they left that morning, with the error code still flashing and the lid still locked. Our diagnosis revealed a failed drain harness causing the drainage malfunction. The Problem … Read more
A Maytag dryer in Massillon wouldn’t start when the customer pressed the button. Our diagnosis revealed multiple failed heating system components that prevented normal operation. The Problem The customer reported that their dryer would not start. When they attempted to begin a cycle, the unit remained completely unresponsive. Diagnosis Testing revealed failures in multiple heating … Read more
A Canton homeowner called about their Maytag washer that would start sensing the load and then the light would go to done. After replacing the lid lock twice without success, we diagnosed capacitor failure with F5E3 and F7E1 error codes. The Problem The customer reported that the washer starts sensing the load and then the … Read more
A Maytag dryer on Ohio Street in Alliance, OH was running but not drying clothes. We found the thermal fuse had blown, cutting off heat to the drum while allowing the motor to continue running. The Problem The customer reported their dryer runs but not drying. The unit would start and tumble clothes normally, but … Read more
A Maytag washer in Homeworth had a pen stuck between the tub and spin basket. The homeowners had already removed the agitator but couldn’t get the basket out to retrieve the pen. The Problem A pen fell between tub and spin basket. The customers had taken the agitator out but couldn’t get the basket out … Read more