We responded to a service call in Homeworth, OH for a Speed Queen washer that filled up with water then it hums and won’t go to wash. Our diagnosis revealed a failed timer that we were able to temporarily repair by breaking loose corroded contacts. The Problem The customer reported that the washer filled up … Read more
A Canton homeowner contacted us about their Whirlpool washer that wasn’t operating properly. Our diagnosis revealed issues with the main control board and pressure sensor that required replacement to restore normal function. The Problem The customer reported their washer was experiencing operational problems that prevented normal washing cycles. The unit needed professional diagnosis to determine … Read more
A Maytag washer in Massillon started smoking during the final spin cycle and stopped working entirely. During the last wash, everything worked fine until the final spin — then there was noise, a cloud of smoke and no spinning. Our diagnosis revealed the issue required immediate attention to prevent further damage. The Problem The customer … Read more
A customer in North Canton called about their LG washer that doesn’t run through the cycle and stops at spin. Our diagnosis revealed a failed drain pump, but given the repair cost and machine age, the customer opted to replace the unit instead. The Problem The washer doesn’t run through the cycle, stops at spin. … Read more
We repaired a 10-year-old Samsung front-loading washer in Canton, OH that was making deep struggling noises and not spinning properly. The customer had to run the spin cycle twice to get clothes ready for drying, and drain codes kept appearing. Our diagnosis pointed to a failed drain pump. The Problem This Samsung washer was making … Read more
A customer in Canton, OH called about their LG washer displaying a UE error code. Our diagnosis revealed the main control board had failed and needed replacement to restore normal operation. The Problem The customer reported their LG washer was showing a UE error code. This error typically indicates an unbalanced load issue, but when … Read more
A Samsung washer in Alliance wouldn’t drain, leaving water sitting in the drum after each cycle. We found the drain filter completely blocked with debris, preventing proper water flow during the drain cycle. The Problem The water won’t drain. The customer reported water remaining in the washer drum after cycles completed, making it impossible to … Read more
A Samsung VRT washer in Alliance, OH was displaying a DC error code and refusing to complete its spin cycle. The machine would start to spin water out, then start beeping and flashing “DC” on the display before recycling and filling with water again. This turned out to be a model covered by Samsung’s recall … Read more
A Canton homeowner called because their Maytag Centennial washer won’t sense there’s a load and doesn’t do anything. We diagnosed multiple system failures that made replacement the better choice than repair. The Problem The customer reported their washer won’t sense there’s a load and doesn’t do anything when they try to start a cycle. Diagnosis … Read more
A customer in Tallmadge called about their Maytag washer that won’t start. When we arrived at the Beechwood Drive location, we found the issue wasn’t with the washer at all — the GFCI outlet was tripped. The Problem The customer reported their Maytag washer won’t start. Both the washer and dryer were completely unresponsive. Diagnosis … Read more